Steinbach Premium 100 Notice Originale page 35

A damaged device or damaged accessories may cause injuries.
- Check the device and the accessories (see section "Testing").
Clarifying agents in the pool water can lead to clumping of the Active Balls and severely
impair their cleaning effect.
- Do not use any clarifying agents for water treatment when using Active Balls as filter
medium.
Selecting the mode
Switch the pump off by pulling the power plug.
14
Press and hold down the valve lever
position and let go.
Pump operation
1. Make sure that all hoses and pipes are correctly connected and that the water level in the pool is at
least 1 to 2" (2.5 to 5 cm) above the opening of the suction line.
2. Check the valve setting of your filter system before you activate the pump.
3. Connect the pump's power plug to the power supply.
The running time display blinks (if a battery is inserted, the last selected running time is displayed).
4. Press the timer button
5. Switch on the pump
The pump starts running at this time and deactivates itself automatically once the selected running
time has expired. The timer activates the pump every day at the same time for the same running
time (once every 24 hours).
The pump is running.
6. Check the pump for unusual noises.
If there is air in the system, bleed it again.
7. Press the ON/OFF button on the timer
Manual stopping the pump deactivates the timer.
The pump is switched off.
Care instructions
The filter system cannot filter out algae, bacteria and other microorganisms.
- Use special water care substances to prevent and remove these to ensure hygienically clean
water.
- Consult an expert and observe the dosage.
Maintenance
Backflushing
Backflushing regenerates the filter and the filter sand. The filter sand must be cleaned by backflushing
prior to the initial start-up and once a week thereafter.
500 to 1100 liters of water are needed for backflushing. This water quantity must be
present before backflushing is started. The pool must be topped up after backflushing
because then there is no risk of dirt in the fresh water supply.
Risk of injury!
on the valve head
38
several times until the LED of the desired running time is lit.
40
by pressing the ON/OFF button on the timer
14
40
CAUTION!
NOTICE!
. Turn the valve lever to the desired
1
to manually stop the pump operation.
.
40
35