Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
"PRM330"
OVERVIEW
The PRM330
solar
charge regulator can charge lead
(liquid, gel and AGM) and lithium 12V batteries
automatically c
ontrolling
supplied by the connected photovoltaic modules.
It
features
a MPPT (Maximum Power Point Tracker)
system that allows picking in every situation of the
maximum power supplied by the photovoltaic
module.
3 phase automatic charging system
Phase 1:
Bulk -
battery charging with maximum
current until the end-
reached.
Note:
the end-
only if the battery is efficient.
Phase 2:
Absorption
end-
of-
charge voltage for the time defined
by the charging line with a progressive
current reduction
completed.
The position of the selector must be set according
to the
most suitable charg
type of battery installed.
I
n most cases, the selector can be set
for led-
acid
batteries,
batteries
, on
position
position
«Li»
for lithium batteries.
Selector on position "A"
Max 14,2V
Selector on position "B"
Max 14,4V
Selector on position "C"
Max 14,7V
Selector on position "Li"
Max 14,5V
Soglia limite
SOLAR
CHARGE REGULATOR
and limiting the energy
of-
charge voltage is
of-
charge voltage is reached
-
battery charging at costant
,
until the charging is
ing
voltages for the
on
position A
on
position
« »
B
for le d-gel
« »
C
for AGM batteries
and on
1
2
3
1h
13,5V
13,8V
4h
13,5V
2h
13,5V
max 1h
The PRM330 is suitable for operation with 32 to 72-
cell photovoltaic modules up to a maximum power of
330W.
For optimal performance, you are advised to connect
the photovoltaic modules with a number of cells over
36, independent of the type of installation chosen (see
the "CONNECTIONS" paragraph).
Phase 3:
Float
voltage.
starting again.
CHARGE LINE SELECTOR.
Line «A»
« »
3
a
2
1
-
Maintenance charg
ing
A h
igh
load
lead to phase
s
Line «B»
Line «C»
3
3
2
2
1
1
EN
at constant
Bulk
Line «Li»
3
2
1
13
Publicité
Table des Matières
