Publicité
Les langues disponibles
Les langues disponibles
E
General
N
G
L
I
S
[MUTE] (Mute/attenuation)
[VOLUME]
H
(SBC-SW)
3
Level meter
[SOURCE]
(This varies the display
(PWR: power)
in line with the volume level.)
Point the remote control unit at the remote control signal sensor.
Power
Turn your car's ignition key
A C C
to the ACC or ON position.
O N
ON:
Press [SOURCE] (PWR).
OFF:
Press and hold [SOURCE] (PWR) until you
hear a beep (about 1 second), then release
it.
Press [SOURCE] (POWER) again and hold
for more than 1 second.
Note:
≥ After turning off the ignition key, a security
message is displayed, and the panel removable
alarm that reminds you to take the panel is
activated.
(When security function is set on to on, page 40)
Demonstration:
When the power is switched on for the fi rst time,
a demonstration appears on the display.
Press [DISP] (display) to change to regular
mode.
Scrolling
Note:
≥ To display the demonstration again, press and
hold [SOURCE] for more than 4 seconds when
turning power on.
22
CQ-C5410/5310/5210/5110U
All manuals and user guides at all-guides.com
[DISP] (Display)
indicator
Spectrum analyzer
(This shows two sets of levels for each of the following frequencies
in sequence starting from the left: 60 Hz, 160 Hz, 400 Hz, 1 kHz,
3 kHz, 6 kHz, 16 kHz.)
Source
Press [SOURCE] to change the source.
CQ-C5410U
CQ-C5310U
Radio (page 26)
CD player (page 29)
or
MP3/WMA player (page 30)
When a MP3/WMA data disc
is in the player.
CD changer control (page 34)
When an optional CD changer
is connected.
AUX (page 57)
[SOURCE]
POWER
MENU
(Power/source)
[VOL "]
SOURCE
SEL
NUMBER
VOL
[MUTE]
[VOL #]
#
MUTE
(Volume)
1
2
3
RAND
SCAN
REP
4
5
6
7
8
9
0
[DISP]
BAND
DISP
SET
(Display)
Car Audio
CQ-C5110U
CQ-C5210U
Radio (page 26)
CD player (page 29)
CD changer control (page 34)
When an optional CD changer
is connected.
Volume
[VOL "]: Up
[VOL #]: Down
Up
Down
Setting range: 0 to 40
(default: 18)
Note:
≥ The volume level can be set independently for
each source. (For radio, one volume setting for
AM, one volume setting for all FMs)
Mute/Attenuation
ON:
Press [MUTE]. (
lights.)
OFF:
Press [MUTE] again.
You can select mute or attenuation. (page 40)
No sounds. (default)
Decrease the volume by 10 steps.
CQ-C5410U
CQ-C5210U
Rear Speakers as Sub-Woofers
(Super Bass Control Subwoofer/SBC-SW)
You can utilize the rear speaker connected to the
built-in amplifi er as Sub-Woofers that output only
bass.
Press and hold [MUTE] (SBC-SW) for more than
2 seconds.
OFF
(Default)
ON
(
lights.)
Note:
≥ When ON has been selected, the settings resulting
from the adjustments performed at the subwoofer
level and subwoofer low pass fi lter settings are
refl ected in the output.
≥ Depending on the speakers used and the type of
music played, it may not be possible to achieve a
satisfactory effect.
CQ-C5410/5310/5210/5110U
E
N
G
L
I
S
H
4
23
Publicité
