Publicité
Les langues disponibles
Les langues disponibles
E
Installation Guide
N
G
L
I
S
Installation Procedures
H
First complete the electrical connections, and then
35
check them for correctness. (page 56)
Remove the
mounting collar 1
and the trim plate 7
from the main unit
temporarily, which
are already mounted
at shipment.
6 Power
connector
Mounting
springs (§)
5 Mounting bolt
Engage the mounting
springs (§) in the
mounting holes of the
Mounting
mounting collar 1
hole
fi rmly.
Mounting springs (§)
(a) Using the rear support strap 3
Fire wall of car
3 mm·
4 Tapping screw
2 Hex. nut
3 Rear support strap
5 Mounting bolt
1 Mounting collar
54
CQ-C5410/5310/5210/5110U
All manuals and user guides at all-guides.com
(continued)
The included mounting collar 1 is designed
specifi cally for this unit. Do not use it to attach
any other model.
1
Insert mounting collar 1 into the
dashboard, and bend the mounting tabs out
with a screwdriver.
The tabs to be bent vary depending on
the car. To securely install the unit, fully
bend a number of the tabs so that there is
no rattling.
Example:
2
Secure the rear of the unit.
After fi xing mounting bolt 5 and power
connector 6, fi x the rear of the unit to the
car body by either method (a) or (b) shown
Mounting holes
below.
3
Insert trim plate 7.
4
After installation,
reconnect the
negative - battery
terminal.
(b) Using the rubber cushion (option)
Rear support bracket
Rubber cushion (option)
(provided on the car)
5 Mounting bolt
1 Mounting collar
Remove the Unit
Switch off the power of the unit.
1
Remove the removable face plate. (page 49)
2
Remove the trim plate 7 with a screwdriver.
3
1
Insert the lock cancel plates 8 along the
grooves on both sides of the main unit
until "click" is heard.
Tab
2
Pull out the unit while pushing the plates
further inside.
4
Remove the unit pulling with both hands.
7 Trim plate
Screwdriver
1
Insert.
Insert the tab
end in the
outer groove.
8 Lock cancel plate
"Click"
2
Pull out.
55
CQ-C5410/5310/5210/5110U
E
N
G
L
I
S
H
36
Publicité
