Tripp-Lite PDUMH15AT Manuel Du Propriétaire page 7

3. Features
1 Primary Input
Model PDUMH15AT/15ATNET: The cord is permanently attached to the PDU and has a
NEMA 5-15P plug.
Model PDUMH20AT/20ATNET: The cord is permanently attached to the PDU and has a
NEMA L5-20P plug.
Model PDUMH20HVATNET: The C19-C20 cord is detachable.
2 Secondary Input Inlet (detachable on all models)
Model PDUMH15AT/15ATNET: The IEC-320-C14 inlet connects to the detachable Secondary
AC Input Power Cord.
Model PDUMH20AT/20ATNET/20HVAT/20HVATNET: The IEC-320-C20 inlet connects to the
detachable Secondary AC Input Power Cord.
3
Switched Outlets: During normal operation, the outlets distribute AC power to connected equipment.
On Models PDUMH15ATNET, PDUMH20ATNET and PDUMH20HVATNET, the NEMA 5-15R,
NEMA 5-15/20R and IEC-320-C13 outlets may be switched On and Off via software control. When
an outlet is live, the associated LED illuminates.
4 Unswitched Outlets (PDUMH20HVAT & PDUMH20HVATNET only): These outlets receive
power from either input source, but are not individually switchable.
5 WEBCARDLX: Allows you to operate this PDU as a managed network device, accessible via
SNMP network management platform, web browser, SSH or Telnet.
6 Factory Port: The port is reserved for configuration by factory authorized personnel only. Do not
connect anything to the port.
7
Digital Load Meter (Ammeter): The total electrical current used by the connected equipment is
displayed on the digital meter in amperes.
Input Voltage Range Select Switch (Model PDUMH20HVATNET): The switch to the lower left of
the display may be used to toggle between "HI" or "LO" voltage ranges. The display will indicate
"HI" or "LO" for five seconds. Press the switch once to display ranges, press again within five
seconds to change setting. Setting can also be changed via PowerAlert. (PDUMH20HVATNET only.)
IP Address Display (Models PDUMH20HVAT & PDUMH20HVATNET): Press and hold the
switch to display the IP address of the SNMP card in the PDU.
8
Input Source Indicator: When the PDU is connected to a live AC power source, the Primary or
Secondary input LED illuminates to indicate which source is supplying power to the PDU outlets.
16-11-163-933688.indb 7
All manuals and user guides at all-guides.com
( continued )
Primary and Secondary AC Input Power Cord (Models
PDUMH20HVAT & PDUMH20HVATNET): Two C19-C20 cables are
included: one for Primary Input, and one for Secondary Input.
Secondary AC Input Power Cord (Model PDUMH15AT/15ATNET):
The detachable cord has an IEC-320-C13 connector and a NEMA 5-15P
plug.
Secondary AC Input Power Cord (Model PDUMH20AT/20ATNET):
The detachable cord has an IEC-320-C19 connector and a NEMA
L5-20P plug.
Input Plug Adapters (Model PDUMH20AT/20ATNET): The adapters
convert NEMA L5-20P input plugs to NEMA 5-20P input plugs.
7
1/3/2017 4:40:16 PM