Bosch MUZ9MX1 Mode D'emploi page 10

en Use
4. Press down carefully until you hear the
blade holder lock into place.
5. Position the blade holder on the glass
blender jug. When doing so, align the
marking G to the handle.
6. Turn the blade holder until the marking
0 on the handle is aligned. You will hear
the blade holder lock into place so it is
fixed in position.
7. Position the blender on the rear red
drive and press down.
8. Rotate the blender as far as possible in
an anticlockwise direction.
Use
W Risk of injury
Never reach into the attached blender!
Never use the blender without the lid in
place.
W Risk of scalding
When you process hot ingredients in the
jug, steam will escape through the filling
opening in the lid. Add a maximum of
0.5 litres of hot or frothing liquid.
Recommended speeds
For blending briefly at maximum
r
speed.
For blending ingredients that do
1­3
not need to be cut up too small.
For blending, frothing and chop-
4­7
ping up.
Not suitable for use with this
z
accessory.
X Image sequence C
1. Prepare your food and add to the
blender jug.
2. Put the lid and locking cap in place.
3. Plug the mains plug into the mains. Turn
the rotary switch to the recommended
setting.
4. Leave switched on until the required
consistency is achieved.
5. Turn the rotary switch to y. Wait
until the drive comes to a standstill.
D isconnect the mains plug.
10
MUZ9MX1_EU_8001017418.indb 10
All manuals and user guides at all-guides.com
6. Rotate the blender in an anticlockwise
■ Clean all parts directly after use.
Adding more ingredients
More ingredients can also be added during
processing. The locking cap can be used
here as a measuring jug (50 ml).
X Fig. D
■ While the appliance is running, remove
W Risk of injury!
Do not insert any objects (e.g. knives,
spoons) in the filling opening in the lid.
Never remove the lid while the appliance is
running!
X Image sequence E
1. To add large quantities or ingredients,
W Risk of injury!
Before removing the lid, check the drive
has come to a standstill. Never switch on
without the lid!
2. Remove the lid.
3. Add the extra ingredients.
■ Put the lid with the locking cap back
direction and remove.
X "Cleaning and maintenance" see
page 11
the locking cap and carefully add more
ingredients through the filling opening in
the lid.
turn the rotary switch to y and wait for
the machine to stop.
in place. Continue processing your
i ngredients. X "Use" see page 10
01.07.2016 11:15:17