Publicité
Les langues disponibles
Les langues disponibles
8416521
TAKING A BREAK
1.
Engage trigger lock (#5). (Fig. 16)
2.
Turn ON/OFF switch (#3) to
OFF/0 position. (Fig. 17)
SHUTTING DOWN
1.
Turn the ON/OFF switch (#3) to OFF/0
position and unplug cord (#14) from outlet. (Fig. 18)
2.
Turn off the water supply. (Fig. 19)
3.
Squeeze trigger for 20-30 seconds to de-pressurize the system.
4.
Release trigger and engage trigger lock (#5). (Fig. 20).
5.
Disconnect the garden hose from the water inlet on the unit. (Fig. 21)
Fig. 18
WASHING BEST PRACTICES
1.
Before cleaning any surface, start with an inconspicuous area to test spray pattern and distance
for maximum cleaning results.
2.
Pre-rinse cleaning surface with fresh water.
3.
If using detergent or degreaser, apply to surface at low pressure. Allow detergent to remain on
surface 1 to 3 minutes.
4.
Do not allow detergent to dry on surface. If surface appears to be drying, simply wet down
surface with fresh water.
5.
Always apply detergent from bottom to top.
6.
Rinse at high pressure in a sweeping motion, keeping the spray nozzle approximately 3 to 6
inches from the cleaning surface.
7.
Always rinse from top to bottom and from left to right.
8.
For best results on decks, cement patios, brick and stone, limit your work area to smaller
sections of approximately 25 square feet. When moving on to a new section of the cleaning
surface, be sure to overlap the previous section to eliminate stop marks and to ensure a more
even cleaning result.
9.
For best results on house siding, limit your work area to sections of approximately 6 feet. When
rinsing, keep the spray nozzle approximately 6 inches from the cleaning surface.
10. For best results on cars, boats & motorcycles, clean one side of vehicle at a time. Keep the
spray nozzle approximately 6 to 8 inches from the cleaning surface. Increase distance when
rinsing pin-striping or other sensitive surfaces. Wipe surface dry with a chamois or
soft dry cloth.
11. For best results on barbecue grills, outdoor power equipment & gardening tools, it may be
necessary to move the spray nozzle even closer to the surface for greater dirt-cutting action.
Visit www.princessauto.com for more information
1.6 GPM @ 1,300 PSI Electric Pressure Washer
Fig. 19
Fig. 16
Fig. 20
Fig. 17
Fig. 21
V 2.9
9
Publicité
