Publicité
Les langues disponibles
Les langues disponibles
8416521
PERSONAL SAFETY
CAUTION! Wear personal protective equipment approved by the Canadian Standards Association
(CSA) or American National Standards Institute (ANSI).
Personal Protective Equipment
1.
Always wear impact safety goggles that provide front and side protection for the eyes. Wear a
full-face shield if your work creates metal filings or wood chips.
2.
Wear gloves that provide protection based on the work materials or to reduce the effects
of tool vibration.
3.
Non-skid footwear is recommended to maintain footing and balance in the work environment.
4.
Wear protective clothing designed for the work environment.
Personal Precautions
Control the tool, personal movement and the work environment to avoid personal injury or
damage to tool.
1.
Do not operate any tool when tired or under the influence of drugs, alcohol or medications.
2.
Do not overreach when operating a tool. Proper footing and balance enables better control in
unexpected situations.
3.
Securely hold this tool using both hands. Using a tool with only one hand can result in
loss of control.
SPECIFIC SAFETY PRECAUTIONS
1.
High pressure sprays can cause serious bodily injury. Do not aim the spray gun at people,
animals or plants.
2.
Do not spray flammable or toxic liquids.
3.
Do not spray near a power source.
4.
Do not leave the spray gun unattended while the unit is running.
5.
Do not lock the spray gun in open position.
6.
Only use a spray gun that has a trigger lock or trigger guard in place and in working order.
7.
Using a pressure washer can create puddles and slippery surfaces. The work area should have
adequate slopes and drainage to reduce the possibility of falling due to slips.
8.
Be careful when squeezing the trigger, as recoil from the spray gun can cause the
operator to fall.
9.
Always operate the pressure washer from a stable surface. Avoid using the pressure washer
from precarious locations such as ladders or scaffolding.
10. Do not attempt to repair damaged or defective high-pressure hoses. Always replace them.
11. Do not repair leaking connections with sealant of any kind. Replace the O-ring or seal.
12. Do not disconnect the high-pressure hose from the pump and spray gun while the
system is pressurized.
13. Always ensure that the spray gun, nozzles, and accessories are correctly attached.
14. Do not use other electrical appliances on the same fuse/breaker box switch as the pressure
washer. This may cause the circuit breaker to trip and cut off power.
15. Do not use an extension cord with this unit; use a longer high-pressure discharge hose instead.
16. Do not plug this pressure water into a hot water supply. This pressure washer is designed for
cold water use only.
17. To minimize the amount of water getting into the pressure washer, the unit should be placed as
far as possible from the cleaning site during operation.
Visit www.princessauto.com for more information
1.6 GPM @ 1,300 PSI Electric Pressure Washer
V 2.9
3
Publicité
