Power Fist 8416521 Mode D'emploi page 12

V 2.9
Problem(s)
No detergent
Garden hose
connection leaks
Spray wand or
extension or
nozzle leaks
Pump makes excessive
noise
Water leaks from pump
(up to 10 drops per
minute
is normal)
Oil drip
12
1.6 GPM @ 1,300 PSI Electric Pressure Washer
Possible cause(s)
Detergent container is empty
Detergent bottle or suction tube not
properly connected
Detergent is too thick
Filter on detergent suction
tube is clogged
Damaged or clogged detergent suction
tube
Nozzle is in high-pressure position
Discharge nozzle is obstructed
Loose fittings
Spray nozzle not properly attached
Broken o-ring or plastic insert
Pump is sucking air
Loose fittings
Water seals are damaged or worn
Oil seals are damaged or worn
Suggested solution(s)
Add more detergent
Check connections
Dilute detergent
Run warm water through filter to remove
debris
Remove obstruction or replace detergent
suction tube
Pull out head of spray wand to low-pressure
position
Blow out or remove debris with thin, sharp
instrument
Tighten fittings
Insert the spray nozzle into the gun assembly.
Carefully press against the spring tension and
twist into the
locked position.
Bring to Princess Auto Ltd. or a
qualified technician
Ensure hose and fittings are airtight. Turn off
unit and purge pump by squeezing trigger
until a steady flow of water emerges through
the nozzle.
Tighten fittings
Bring to Princess Auto Ltd. or a
qualified technician
Bring to Princess Auto Ltd. or a
qualified technician
For technical questions call: 1-800-665-8685
8416521