Publicité
Les langues disponibles
Les langues disponibles
V 2.9
MAINTENANCE
1.
Maintain the tool with care. A tool in good condition is efficient, easier to control and will have
fewer problems.
2.
Inspect the tool components periodically. Repair or replace damaged or worn components.
3.
Follow instructions for lubricating and changing accessories.
4.
Keep the tool handles clean, dry and free from oil/grease at all times.
CAUTION! Only qualified service personnel should repair the tool.
PRESSURE WASHER MAINTENANCE
CAUTION! Ensure the pressure washer is disconnected from power
source and water supply and that the system is depressurized before
doing any of the following maintenance.
Cleaning the Water Inlet Filter
1.
Remove cover from the water inlet (#15). (Fig. 22)
2.
Remove water inlet filter using flat nose pliers.
3.
Rinse out water inlet filter in warm water. (Fig. 23)
4.
Reinsert water inlet filter and cover.
Cleaning Nozzles
If the nozzle becomes clogged, pressure can build inside the pump
and cause the unit to surge. Clean the nozzle by carefully inserting a thin, sharp instrument, such as a
paperclip, into the tip to rid it of deposits.
STORAGE
If you must store your pressure washer in a place where temperature is below 5°C (41°F), you need to
apply winterizing procedure to protect it. Failure to do so may permanently damage the pump.
Optimum Winterizing Procedure
NOTE: Using pump saver, available at Princess Auto, will keep the internal parts lubricated, protected from
rust and prevents the pump from freezing.
1.
Disconnect pressure washer from power source and water supply.
2.
Connect the pump saver hose to water inlet (#15).
3.
Depress button on pump saver container.
4.
Continue until fluid exits the pump outlet (#1).
5.
Remove the hose from pump inlet.
Alternative Procedure
If you cannot perform the optimum winterizing procedure, you can still protect your pressure washer
from winter damage:
1.
Disconnect all water connections.
2.
Turn on the unit for a few seconds. Squeeze trigger to bleed any remaining water in the pump.
Tum off immediately.
3.
Remove the gun (#6) and hose (#8) from the pressure washer. Drain any excess water. Roll
hose carefully and do not allow it to become kinked.
4.
Store the unit and accessories in a room that does not reach freezing temperatures. Do not
store near furnace or other heat sources of heat as it may dry out the pump seals.
10
1.6 GPM @ 1,300 PSI Electric Pressure Washer
Fig. 22
Fig. 23
For technical questions call: 1-800-665-8685
8416521
Publicité
