Publicité
Les langues disponibles
Les langues disponibles
V 2.9
OPERATION
1.
Prepare the work area for cleaning, including ensuring all doors and windows are closed tight.
2.
Before turning the unit ON, move the trigger lock (#5) out of the way and squeeze the trigger to
bleed any trapped air out of the pump and hose. (Fig. 10) Wait for a steady stream of water to
emerge from the spray wand, then release trigger.
3.
Start the pressure washer by turning the ON/OFF switch (#3) to the ON/1 position. (Fig. 11)
4.
Move the trigger lock out of the way and begin spraying by squeezing the trigger.
NOTE: The trigger lock prevents the trigger from accidentally being engaged. This safety feature
does not lock trigger in the "ON" position.
5.
The nozzle of the spray wand (#7) can be adjusted from 0 to 60° spray pattern. (Fig. 12)
CAUTION: The 0° spray setting is very aggressive. Do not adjust while spraying. We recommend that
for most cleaning applications, a 20° spray angle should be used to avoid damage to the surface
being sprayed.
Fig. 10
USING DETERGENT
To enhance the efficiency of the pressure washer, sometimes it is necessary to use
detergents to help loosen tough dirt and grime.
1.
Ensuring the ON/OFF switch (#3) in the OFF/0 position, pull the head of the
spray wand (#7) as shown. (Fig. 13)
2.
Fill the detergent bottle (#13) with the selected detergent. (Fig. 14)
3.
Turn the ON/OFF switch to the ON/1 position and squeeze trigger. (Fig. 15)
Liquid detergent will be automatically drawn into the unit and mixed
with water.
4.
Apply detergent to work area. Do not allow detergent to dry on surface.
5.
To rinse, release the trigger and push head of the spray wand back into its
original position. Squeeze the trigger and rinse the surface in a
sweeping motion.
CAUTION: This unit has been designed for use with pressure washer
detergents only. The use of other detergents or chemicals may
damage the unit.
6.
When detergent is no longer needed, insert the detergent suction tube
into a container of fresh water.
7.
Set the nozzle to the low-pressure setting.
8.
Squeeze and hold the trigger for 20 to 30 seconds, allowing fresh water to
rinse through the detergent injection system.
8
1.6 GPM @ 1,300 PSI Electric Pressure Washer
Fig. 11
For technical questions call: 1-800-665-8685
8416521
Fig. 12
Fig. 13
Fig. 14
Fig. 15
Publicité
