Power Fist 8416521 Mode D'emploi page 11

8416521
DISPOSAL
Recycle a tool damaged beyond repair at the appropriate facility.
TROUBLESHOOTING
Contact Princess Auto Ltd. for a solution if the tool does not function properly or parts are missing. If
unable to do so, have a qualified technician service the tool.
Problem(s)
Motor will not start
Unit does not reach
high pressure
Output pressure varies
high and low
Visit www.princessauto.com for more information
1.6 GPM @ 1,300 PSI Electric Pressure Washer
Possible cause(s)
ON/OFF switch is in OFF position
Power cord is not plugged in
Electrical outlet does not supply
adequate power
Tripped GFCI plug
Tripped circuit breaker
Diameter of garden hose is too small
Water supply is restricted
Not enough inlet water supply
Water inlet filter is clogged
Nozzle is in low pressure position
Not enough inlet water supply
Pump is sucking air
Water inlet filter is clogged
Discharge nozzle is obstructed
Calcium deposits in gun,
hose, or wand
Suggested solution(s)
Turn switch to ON position
Plug in power cord
Try a different outlet
Press RESET button on GFCI plug
Turn off pressure washer. Verify that only the
pressure washer is running on this circuit
Replace with 5/8 in. garden
hose or larger
Check garden hose for kinks,
leaks and blockage
Turn water on full force
Remove filter and rinse
out in warm water
Push in head of spray wand to
high-pressure position
Turn water on full force. Check garden hose
for kinks, leaks or blockage.
Ensure hose and fittings are airtight. Turn off
unit and purge pump by squeezing trigger
until a steady flow of water emerges through
the nozzle.
Remove filter and rinse
out in warm water
Blow out or remove debris
with thin, sharp instrument
Run distilled vinegar through
detergent suction tube
V 2.9
11