GYS POWERDUCTION 10R Mode D'emploi page 12

Translation of the original instructions
Flexible braided wire
The braid is designed for pieces that cannot be heated with the coil (parts with a bigger diameter) :
Ex. an exhaust pipe or a wheel hub
The braid can be enrolled around the metal piece.
To obtain a better result, circle 3 times around the metal piece and make sure that the coils are bonded together. Press
the inductor's button to start the charge.
Straight rigid wire
The straight rigid wire is designed to suit any of the user's needs. It can be :
- adjusted to the shape of a specific part/piece.
- adjusted to a piece that is too big for the coils.
- copy the shape of an existing coil if the latter is damaged.
It works in the same way as coils and braided wire. Its shape must be adjusted to fit the metal piece's shape and if
possible, circle around the piece several time for maximum efficiency.
RECOMMENDATIONS
• When heating the coils for the first time, some smoke will be released.
• Avoid heating for more than 30s, the coils will heat excessively and suffer premature damages.
• It is not necessary to come in contact with the bolt to heat it.
• The coil's protective fabric is fragile, it is glass fabric : make sure to store the coils in such a way that they do not
get damaged.
The coils heat very fast. After use, is is recommended to let them cool down before storing them. Ma-
nipulate with gloves to prevent burns or itches caused by the glass fabric.
Do not place a finger or any limb inside or close to the coil when the machine is switched on. Magnetic
fields should be considered.
PRODUCT SPECIFICATIONS
Power
Operating voltage
Power supply frequency
Heater Frequency
12
All manuals and user guides at all-guides.com
POWERDUCTION 10R
Heating efficiency :
To achieve maximum heating power efficiency, the coil must be adapted to the
workpiece.
fig.2
10R
1,2 kW
230 V +/- 15%
50 Hz - 60 Hz
45-100 kHz, microprocessor controlled.
EN