Publicité
Les langues disponibles
Les langues disponibles
IMPORTANT SAFETY INSTRUCTIONS (continued)
19. Do not leave the cord lying on the floor once you have finished the cleaning job. It can become
a tripping hazard.
20. Use special care when emptying heavily loaded tanks.
21. To avoid spontaneous combustion, empty tank after each use.
22. The operation of a utility vac can result in foreign objects being blown into eyes, which can
result in eye damage. Always wear safety goggles when operating vacuum.
WARNING
– DO NOT LEAVE VACUUM UNATTENDED WHEN IT IS PLUGGED IN AND/OR OPERATING. UNPLUG
UNIT WHEN NOT IN USE.
This appliance must be grounded. If it should malfunction or breakdown, grounding provides
a path of least resistance for electric current to reduce the risk of electric shock. This appli-
ance is equipped with a cord having an equipment-grounding conductor and grounding plug.
The plug must be inserted into an appropriate outlet that is properly installed and grounded
in accordance with all local codes and ordinances.
WARNING
– IMPROPER CONNECTION OF THE
EQUIPMENT-GROUNDING CONDUCTOR CAN RESULT IN A
RISK OF ELECTRIC SHOCK. CHECK WITH A QUALIFIED
ELECTRICIAN OR SERVICE PERSON IF YOU ARE IN
DOUBT AS TO WHETHER THE OUTLET IS PROPERLY
GROUNDED. DO NOT MODIFY THE PLUG PROVIDED WITH
When using the appliance at a distance where an extension cord becomes necessary, a 3-con-
ductor grounding cord of adequate size must be used for safety, and to prevent loss of power
and overheating. Use the table below to determine A.W.G. wire size required. To determine
ampere rating of your vacuum, refer to nameplate located on rear of motor cover.
Before using appliance, inspect power cord for loose or exposed wires and damaged insula-
tion. Make any needed repairs or replacements before using your appliance. Use only three-
wire outdoor extension cords which have three-prong grounding-type plugs and three-pole
receptacles which accept the extension cord's plug. When vacuuming liquids, be sure the
extension cord connection does not come in contact with the liquid.
NOTE: STATIC SHOCKS ARE COMMON IN DRY AREAS OR WHEN THE RELATIVE HUMIDITY OF
THE AIR IS LOW. THIS IS ONLY TEMPORARY AND DOES NOT AFFECT THE USE OF THE APPLI-
UNPACKING AND SET-UP
1. Pull lid latches in an outward motion and remove tank cover and any accessories which
may have been shipped in the tank.
2. Attach dolly, carriage handle and basket following the instructions and illustrations
below.
3. Before replacing tank cover, refer to Dry Pick-Up or Wet Pick-Up Operation in this manual
to ensure you have the proper filters installed and inlet deflector is positioned correctly
for your cleaning operation.
4. Your vacuum comes with the filters already installed for dry pick-up. For filters
recommended for wet pick-up refer to wet pick-up operation.
5. Be sure inlet deflector is in proper position.
6. Replace tank cover and apply pressure with thumb to each latch until it snaps tightly in
place. Make sure both lid latches are clamped securely.
7. Insert long machine hose end with locking-nut into inlet of tank and tighten.
Do not over-tighten. Twist slightly for proper seal.
8. Attach ergonomic elbow grip to accessory end of hose for a more comfortable hand grip
while vacuuming. (Not standard on all models)
9. Attach the extension wands to the ergonomic elbow grip. (Not standard on all models)
10.Attach one of the cleaning accessories (depending on your cleaning requirements)
on the extension wands.
11.Plug the cord into the wall outlet. Your cleaner is ready for use.
O = Off; I = On
All manuals and user guides at all-guides.com
SAVE THESE INSTRUCTIONS
GROUNDING INSTRUCTIONS
EXTENSION CORDS
23. STAY ALERT. Watch what you are doing and use common sense. Do not use vac-
uum cleaner when you are tired, distracted or under the influence of drugs, alco-
hol or medication causing diminished control.
THE APPLIANCE – IF IT WILL NOT FIT THE OUT-
LET, HAVE A PROPER OUTLET INSTALLED BY A
QUALIFIED ELECTRICIAN.
This appliance is for use on a nominal 120-volt
circuit, and has a grounded plug that looks like
the plug illustrated in sketch A.
NOTE: IN CANADA, THE USE OF A TEMPORARY
ADAPTER IS NOT PERMITTED BY THE CANADIAN
ELECTRICAL CODE.
ANCE. TO REDUCE THE FREQUENCY OF STATIC SHOCKS IN YOUR HOME, THE BEST
REMEDY IS TO ADD MOISTURE TO THE AIR WITH A CONSOLE OR INSTALLED
HUMIDIFIER.
Total length of cord in feet
Volts
120V
25
Ampere Rating
More
Not More
Than
Than
18
0
-
6
6
- 10
18
10
-
12
16
14
12
-
16
NOTE: MANY MORE USEFUL TOOLS ARE AVAILABLE AT YOUR LOCAL DEALER,
SERVICE CENTER, OR SHOP-VAC
®
WEBSITE.
DOLLY, CARRIAGE HANDLE AND
BASKET ASSEMBLY
2
1
3
8
Tank
Machine
Screw
Dolly
Hex
Flat
Nut
Washer
150
50
100
AWG
16
16
14
16
14
12
16
14
12
12
Not recommended
11
5
7
6
10
9
4
Bottom of Tank
Publicité
