Maytag MDD8000AW Manuel D'instruction page 5

CYCLE SELECTIONS
CYCLES DISH LOAD TYPES
Use to quickly wash
prerinsed glasses or dish
loads.
You can customize your cycle by selecting an option.
See option selections. If you change your mind, press the option again to turn off the option, or select a different option. You can change
an option anytime before the selected option begins.
*Maximum wash times depend on water temperature, heavy soil condition, dish load size and options selected.
NOTE: Dry time (fan running) is typically 4 hours after wash cycle. After 30 minutes of dry time, the clean light will illuminate. Anytime after
the clean light is lit and the drawer is opened for longer than 30 seconds, the cycle will be terminated.
OPTION SELECTIONS
OPTIONS DISH LOAD TYPES
Loads containing tough,
baked-on food.
To run your dishwasher at
a later time or during off-
peak hours.
Control Lock To avoid unintended use of
your dishwasher, or cycle
and option changes during
a cycle.
IMPORTANT: The sensor in your dishwasher monitors the soil level. Cycle time and/or water usage can vary as the sensor adjusts the
cycle for the best wash performance. If the incoming water is less than the recommended temperature or food soils are heavy, the cycle
will automatically compensate by adding time, heat and water as needed.
CONTROLS AND
CYCLE STATUS
CONTROL PURPOSE
To start or resume a
wash cycle
To cancel wash
cycle
To follow the
progress and status
of your dishwasher
cycle
All manuals and user guides at all-guides.com
DESCRIPTIONS
This cycle does not dry.
DESCRIPTIONS
Increases the target water temperature during the wash
portions of the cycle.
Adds heat, wash time and water to the cycle.
Delays the start of a cycle up to 6 hours.
Select a wash cycle and options. Press 6 Hour Delay. Press
START/RESUME. Close the drawer firmly.
To turn on Lock, press and hold Control Lock for at least
3 seconds.
To turn off Lock, press and hold Control Lock for at least
3 seconds.
When Control Lock is lit, all buttons are disabled. If you press
any pad while your dishwasher is locked, the light flashes
3 times. The dishwasher drawer can be opened while the
controls are locked.
COMMENTS
If the drawer is opened during a cycle, a delay, or the power is interrupted, the Start/Resume
indicator flashes. To restart the drawer, open the drawer, press Start/Resume and close the
drawer firmly within 4 seconds.
Close the drawer firmly. The dishwasher starts a 2-minute drain (if needed). Let the dishwasher
drain completely. If the Cancel button is pressed a second time, the drawer will turn off.
Clean indicator glows when a cycle is finished.
Rinse aid low indicator light glows when the rinse aid dispenser needs to be refilled.
WASH TIME (HH:MM)
Cycle Cycle + Options
Minimum Minimum
0:30 none
USE WITH:
Sensor Wash, Heavy
Duty or Normal Wash
All cycles, except Rinse
Only
Anytime
*Maximum
none
5