Publicité
Les langues disponibles
Les langues disponibles
■
Rinse aid keeps water from forming droplets that can dry as
spots or streaks. They also improve drying by allowing water to
drain off of the dishes after the final rinse.
■
Rinse aid helps to reduce excess moisture on the dish racks
and interior of your dishwasher.
■
When the dispenser is low and needs to be
refilled, an indicator light on the control panel
will illuminate.
■
To add rinse aid, turn
the dispenser cap a ¹⁄₄
turn counterclockwise
and remove. Pour
rinse aid into the
opening until the liquid
reaches the FULL
level marking. Replace
the dispenser cap and
turn clockwise until
the cap is secure.
NOTE: For most water conditions, the factory setting of 3 will give
good results.
Select a Cycle (cycles vary by model)
See "Cycle and Option Descriptions" charts in the following
section.
Heavier cycles and options affect cycle length. Some cycles and
options will take up to 2¹⁄₂ hours to complete.
This information covers several different models. Your dishwasher may not have all of the cycles and options described.
CYCLE SELECTIONS
CYCLES
DISH LOAD TYPES
Use for loads with normal
amounts of food soil.
Use for hard-to-clean, heavily
soiled pots, pans, casseroles,
and regular tableware.
Use for loads with normal
amounts of food soil.
Use for lightly soiled items or
china and crystal.
4
All manuals and user guides at all-guides.com
¹⁄₄ turn to lock
STEP 3
Cycle and Option Descriptions
DESCRIPTIONS
This cycle uses a sensor to adjust
amount of water, time and heat.
This cycle forces max time, water and
heat.
The energy-usage label is based on this
cycle.
This cycle washes at lower temperatures.
Towel drying may be required.
Select Options (options vary by model)
See "Cycle and Option Descriptions" charts in the following
section.
You can customize your cycles by pressing the options desired. To
Cancel an option, press it again.
Start or Resume a Cycle
■
Prior to starting the dishwasher, turn the hot water
on at the sink next to the dishwasher. Let the water
run until it is hot. This ensures that hot water will
enter the dishwasher when it is started. Make sure
to turn the sink water off.
■
Select the wash cycle and options desired.
■
Press START/RESUME button once and close the drawer. After
a brief pause, the cycle will begin. The drawer must be closed
within 4 seconds after pushing START/RESUME or the lights
will flash, a tone will sound, and the dishwasher will not begin.
Press the START/RESUME button again and shut the drawer
within 4 seconds.
■
You can add an item anytime before the main wash starts.
Open the drawer slowly and add the item. Press the START/
RESUME then close the drawer.
NOTE: If you have a two drawer dishwasher model, each drawer
has its own controls and can run independently of the other.
Cycle
Minimum
1:15
1:30
1:05
1:00
STEP 4
WASH TIME (HH:MM)
Cycle + Options
*Maximum
Minimum
1:30
1:30
1:30
1:00
2:10
2:10
2:10
1:20
Publicité
