Identification Data; Technical Description; Intended Use; Safety - Hillyard Trident FMD20 Manuel D'utilisation

Table des Matières

Les langues disponibles

For technical assistance or to request replacement parts, always give the model, the version and serial number written on the serial number

plate.

This appliance has been built for the professional cleaning of indoor hard vinyl floors, to be carried out by following the instructions. The

appliance must only be used for this purpose.

This appliance was designed and built to be used by a qualified

operator to clean smooth, compact flooring in the commercial,

residential and industrial sectors, in proven safety conditions. The

machine is suitable for carpet floor cleaning if used with proper

accessories. The appliance is only suitable for use in indoor - or at

least covered - areas.

Operator cooperation is paramount for accident prevention. No

accident prevention programme can be effective without the full

co-operation of the operator who is directly responsible for machine

operation. The majority of occupational accidents that happen both

in the workplace or whilst moving are caused by failure to respect

The serial number plate is located at the rear of the handlebar, and

indicates the general characteristics of the appliance, in particular

the appliance's serial number. The serial number is a very important

piece of information and should always be provided together with any

request for assistance or when purchasing spare parts.

TECHNICAL DATA

Working width

Pad holder diameter

Engine speed

Number of orbits dragging disc

Brush head motor rated power

Brush head motor nominal voltage

Brush head motor frequency

Maximum gradient with full load

Solution tank capacity (optional)

Rear wheels (diameter / width)

Appliance length

height of the appliance to the brush head carter

Height of the appliance to the shaft

Appliance width

Appliance service weight (without solution tank)

Length of power supply cable