Trix 285 ITL Serie Manuel page 7

Safety Notes
• This locomotive is only to be used with the operating
system it is designed for.
• Use only switched mode power supply units and transfor-
mers that are designed for your local power system.
• This locomotive must never be supplied with power from
more than one power pack.
• Please make note of the safety notes in the instructions
for your operating system.
• The feeder track must be equipped to prevent inter-
ference with radio and television reception, when the
locomotive is to be run in conventional operation. The
611 655 interference suppression set is to be used for this
purpose. The interference suppression set is not suitable
for digital operation.
• Do not expose the model to direct sunlight, extreme
changes in temperature, or high humidity.
• WARNING! Sharp edges and points required for operation.
General Notes
• The operating instructions and the packaging are a com-
ponent part of the product and must therefore be kept as
well as transferred along with the product to others.
• Please see your authorized Trix dealer for repairs or spare
parts.
• http://www.maerklin.com/en/imprint.html
All manuals and user guides at all-guides.com
Functions
• Built-in electronic circuit for operation with a conven-
• Automatic system recognition between digital and analog
• The full range of functions is only available under Trix
• Built-in headlights that change over with the direction of
Notes on digital operation
• The operating instructions for your central unit will give
• The values set at the factory were selected to guarantee
• The setting done at the factory does not permit operation
No warranty or damage claims shall be accepted in those cases where
parts neither manufactured nor approved by Trix have been installed in
Trix products or where Trix products have been converted in such a way
that the non-Trix parts or the conversion were causal to the defects and /
or damage arising. The burden of presenting evidence and the burden of
proof thereof, that the installation of non-Trix parts or the conversion in or
of Trix products was not causal to the defects and / or damage arising, is
borne by the person and/or company responsible for the installation and /
or conversion, or by the customer.
tional DC power pack (max. ±12 volts), Trix Systems or
NMRA DCC digital systems.
operation.
Systems and under DCC.
travel. They can be turned on and off in digital operation.
you exact procedures for setting the different parame-
ters.
the best possible running characteristics.
with opposite polarity DC power in the braking block.
If you want this characteristic, you must do without
conventional DC power operation (CV 29 / Bit 2 = 0).
7