Aqua Medic YASHA advanced Mode D'emploi page 7

5.2. Assembly
On unpacking, please check the lighting system immediately for any damages. In case of any
complaints, please contact your dealer directly.
The three holding units for the light have to be put on the back pane of the aquarium.
aquasunspots are put in the sockets by using a cross headed screwdriver.
Afterwards, each light has to be put in the corresponding holding unit. The shorter light has to be
put into the middle. The light power lines have to be connected to the transformer.
5.3. Safety Instructions
The lights may become very hot during operation. Be careful when touching them!
•
In case of changing bulbs, disconnect the light from the mains and let it cool down.
•
When cleaning, take care that no humidity passes the ventilation and enters the interior of the
•
lighting system!
5.4. Maintenance and Care
Clean the lenses regularly (caution: let them cool down) from residues of water splashes and
evaporation with a moistened cloth. Never use any additional cleaning agents!
6. Operating the aquarium
For operating the YASHA, we recommend our Reef Life series as acessories:
Reef Life Calcium supplies corals with essential calcium and trace elements.
•
Reef Life Iodine is essential for the care of many corals.
•
If both additives are applied combined and regularly, they guarantee for successful salt-water
aquarist.
We recommend to prepare your sea water with osmosis water in order to minimize from the
beginning algae problems by silicic acids, phosphates and nitrates. Sea-salt of Aqua Medic is
formulated from highly purified compounds. In this way, both products will support you to keep the
content of the above-mentioned substances as low as possible.
The fixing of rocks and corals can easily be done with the underwater adhesive Reef Construct.
All manuals and user guides at all-guides.com
7