Publicité
Les langues disponibles
Les langues disponibles
STEP 4: INSTALLING THE OVEN
Removing the Oven Door
(CM301 oven door and CM302 upper door are not
removable).
For ease of installation, some oven door(s) may
be removed to reduce the weight of the oven by
30 pounds per door, before installing into the
cabinet. See instructions below.
Fig. 4
Door Hinge Close-up View
To Remove the Oven Door
1. Fully open the oven door.
2. Raise the U-clip over the hook on each of the
hinges to the "locked" position (see illustration
above). This will prevent the hinge from
snapping closed when the door is removed.
3. Grasp the door by the sides toward the back.
Raise the front of the door several inches (there
will be some spring resistance to overcome
because of the hinge being locked). When the
front of the door is high enough, you will be
able to lift the hinges to clear the indents.
4. Pull the hinges out of the slots in the oven front
frame.
Remove the Bottom Trim
Remove the bottom trim from the top of the unit.
Remove the base skid. See Figure 1 (Page 3)
and Figure 5, Page 10.
Slide the Oven into Opening
Slide the oven into the opening being careful not
to scratch side trims. Secure oven with the 4
screws provided (2 each side) through the side of
the front frame into the cabinet.
Replace the Door(s)
After installing the unit, replace the door(s); be
certain both hinge arms are well inserted and
secure, and that the hinge latch is fully released.
All manuals and user guides at all-guides.com
HINGE CLIP
HINGE ARM
9
CAUTION
DO NOT MOVE OR LIFT OVEN BY DOOR
HANDLE. DOOR GLASS BREAKAGE MAY OCCUR.
THE DOOR OF THE CM301 AND THE UPPER
DOOR OF THE CM302 ARE NOT REMOVABLE
BECAUSE THEY ARE PART OF MICROWAVE
SEAL.
USE CAUTION WHEN REMOVING THE
DOOR(S). DOORS ARE VERY HEAVY.
• The oven doors are heavy and fragile.
Use both hands to remove or replace
the door.
• Grasp only the sides of the oven door
when removing or replacing it.
• Failure to grasp the oven door firmly
and properly could result in personal
injury and product damage.
• With the door off, never release the
levers and try to close the hinges.
Without the weight of the door, the
powerful springs will snap the hinges
closed with great force.
WARNING
To avoid injury from hinge bracket snapping closed,
be sure that both levers are securely in place before
removing door.
Also, do not force door open or closed - the hinge
could be damage and injury could result.
IMPORTANT: Reinstall the door very carefully. Be
certain that the hinge arm does not hit the
porcelain collar around the clearance slot or it will
chip the porcelain.
To Replace the Oven Door
1. Grasp the sides of the door at the center and
insert the ends of the hinges into the slots in
the oven front frame as far as they will go (see
illustration below).
2. With the door open all the way, lower the two
locking clips.
3. Raise the oven door and make sure that it fits
evenly with the front sides.
4. Close and open door slowly to be sure it is
correctly and securely in place.
:
Publicité
