Publicité
Les langues disponibles
Les langues disponibles
STEP 2: CABINET PREPARATION
The cabinet cutout dimensions for wall mounted
and under the counter installations are shown in
Figs. 2 and 3, respectively.
It is good practice, when oven is installed at the
end of a cabinet run, adjacent to a perpendicular
wall or cabinet door, to allow at least 1/4" space
between the side of the oven door and the wall/
door.
Wall Mounted Units
For oven support, install 2 x 4's extending front
to back flush with the bottom and the side of the
opening.
The supporting base must be well secured to the
floor/cabinet and level with the floor line.
Wall Mounted Installation
Figure 2- Cabinet Cutout - Wall Mounted Installation
Refer to dimensions for specific ovens on Page 5
FRONT VIEW
Preferred
Location
of Conduit
Box
A
2x4 Supports
(Wall Stud)
D
FLOOR
LINE
All manuals and user guides at all-guides.com
F
E
Post Supports
Required Near
Back
Side Frame
B
Overlap
5/8" Cabinet
(1, 6 cm)
Conduit Box May be Placed
Here
NOTE:
The conduit box for double ovens
(SEC272, SECD272, SEC302, SECD302, C272,
C302, CM302, SEMW272 and SEM272) should be
located above the unit to facilitate connecting and
servicing. For single ovens (SEC301, C271, C301,
and CM301) the conduit box may be installed
either above or below the unit. If the conduit box
is installed below the unit, a 2" diameter hole or
space is required between the back wall and the
right rear of the 2 x 4 supports. See Figure 2.
When an oven is installed, the cabinet base must
be capable of supporting the oven weight as listed
below:
O
V E N
SE-series Single Oven
C-series Single Oven
CM Single Oven
S-series Double Oven
C-series Double Oven
CM Double Oven
SIDE VIEW
G
C
Frame
Overlap
(Top) 3/8"
(1, 0 cm)
Cabinet
Recommended
2" Diameter Hole (4.5
cm)
Exposed Edge
Must be a Finish-
Cut
H
4
P
K
O U N D S
ILOGRAMS
165
75
210
95
240
109
330
150
355
161
370
168
Double Oven
Location of
Conduit Box
2-1/2" (6, 4
cm)
Above
Unit
CONDUIT BOX IS NOT
FURNISHED WITH UNIT
Approx. 5" (13 cm)
Publicité
