ETI 53081141 Guide D'utilisation Et D'entretien page 4

install with Junction Box (continued)
5
Inserting the spring clips
□ Compress the spring clips on the LED downlight (A) and
insert into the hole in the ceiling.
A
install without Junction Box
1
Turning off the power
□ Make sure the power is turned off at the source
to where the LED downlight (A) will be installed.
Remove the recessed can, keeping the metal
conduit.
6
Positioning the LED downlight
□ Release the spring clips and carefully push the LED
downlight (A) into the ceiling cutout until the trim is flush
with the ceiling surface.
A
2
Removing metal conduit from
downlight
□ Rotate the metal conduit
attached to the LED downlight
(A) in a counter-clockwise
direction to remove it.
Metal conduit
A
6
install without Junction Box (continued)
3
Opening downlight junction box
□ Open the cover of the LED downlight (A) junction box
from the corner using a flathead screwdriver (not
included).
Cover of LED
downlight (A)
junction box
A
5
Covering wire connections
□ Cover wire connections using the wire connectors (B)
and replace the LED downlight (A) junction box cover.
B
B
A
4
Connecting the wires
□ Remove wires from connector in the LED downlight
junction box, then connect the wires from the metal
conduit as follows:
- Connect black wire to "L" of driver
- Connect white wire to "N" of driver
- Connect brown wire to "+" of dimmer
- Connect blue wire to "-" of dimmer
6
Inserting the spring clips
□ Compress the spring
clips on the LED
downlight (A) and
insert into the hole in
the ceiling.
A
7
Positioning the LED downlight
□ Release the spring clips
and carefully push the LED
downlight (A) into the ceiling
cutout until the trim is flush
with the ceiling surface.
A
7 WWW.ETiSSL.COM
Please contact 1-855-384-7754 or further assistance.