Table of Contents
Table of Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Safety Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Limited Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Pre-Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Planning Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Tools Required . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
safety information
WarninG: Carefully read and understand the
information given in this manual before beginning the
assembly and installation. Failure to do so so could lead to
electric shock, fire, or other injuries which could be hazardous
or even fatal.
WarninG: Ensure the electricity to the wires you
are working on is shut off. Either remove the fuse
or turn off the circuit breaker
.
WarninG: Risk of fi re or electric shock. Installation of this
LED Retrofit Kit assembly requires a person familiar with the
construction and operation of the light fixture's/luminaire's
electrical system and the hazard involved. If not quali fied, do
not attempt installation. Contact a qualifi ed electrician.
WarninG: Install this kit only in luminaires (light fixtures)
that have the construction features and dimensions shown in
the photographs and/or drawings included in these installation
instructions, and where the input rating of the retrofi t kit does
not exceed the input rating of the luminaire.
WarninG: Do not make or alter any open holes in an
enclosure of wiring or electrical components during kit
installation.
WarninG: To prevent wiring damage or abrasion, do not
expose wiring to edges of sheet metal or other
sharp objects.
Package Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Install with Junction Box . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Install without Junction Box . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Care and Cleaning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
nOTiCe: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the
following measures:
□ Reorient or relocate the receiving antenna.
□ Increase the separation between the equipment and the receiver.
□ Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
□ Consult the dealer or an experienced radio/TV technician for help.
nOTiCe: NOT FOR EMERGENCY LIGHTING.
2
Limited Warranty
This product is warranted for a period of 5 years from the date of original purchase against defects in materials and workmanship. If this
product should fail to operate due to defects in material or workmanship within 60 months of purchase, see www.etissl.com for details.
This product will be repaired or replaced, at ETi's option. This warranty is expressly limited to repair or replacement of product and liability
for direct, incidental, or consequential damages is hereby expressly excluded. Some states do not allow exclusions of direct, incidental or
consequential damages so the above limitation of exclusion may not apply to you. This warranty gives the consumer specifc legal rights,
which vary from state to state. WARRANTY IS VOID IF PRODUCT IS NOT USED FOR THE PURPOSE WHICH THIS PRODUCT IS MANUFACTURED.
Pre-installation
PLANNING INSTALLATION
Before beginning assembly, installation or operation of product, make sure all parts are present. Compare parts with the package
contents list. If any part is missing or damaged, do not attempt to assemble, install or operate the product. Contact customer service for
replacement parts.
WarninG: Shut off the power at the circuit breaker or fuse panel before removing the old fi xture.
nOTe: Keep your receipt and these instructions for proof of purchase.
TOOLS ReqUIRed
Wire strippers
Safety goggles
Flathead
Phillips
screwdriver
screwdriver
Ladder
Electrical
tape
3
WWW.ETiSSL.COM
Please contact 1-855-384-7754 or further assistance.
Gloves
Wire
Cutters