Dentsply Sirona CEREC MC Mode D'emploi page 17

Dentsply Sirona
Supplement to the Operating Instructions, Barcode Reader
63 22 346 D3439
D3439.201.05.04.02 04.2019
All manuals and user guides at all-guides.com
1
Introduction
This document describes the use of the bar code reader. The Starting
the milling process [→ 7] chapter replaces the procedure described in
your operating instructions.
File this document in your manual and always proceed as outlined in
this description in the future.
Important: The bar code reader can only be used from software version
V3.80 onward.
1 Introduction
3