STEINEL XSolar SOL-O Sensor Mode D'emploi page 14

11� Technical specifications
Technical specifications for
solar light
Dimensions: (W × H × D (in mm)
Output
Angle of coverage
Detection reach
Twilight setting
Time setting
Night light
Luminous flux
Efficiency
Colour temperature
LED life expectancy
IP rating
Protection class
Temperature range
Technical specifications for
rechargeable battery
Type
Capacity
max. life expectancy
Micro USB charging socket
10� Troubleshooting
Malfunction
Red LED flashing in motion
detector / light
Light does not switch ON
Light does not switch OFF
Light switches ON when it
should not
Battery not charging
Risk of damage to property when
light is not in use
110073820_STE_XSolar SOL-O S_SOL-O_HN.indd 14 110073820_STE_XSolar SOL-O S_SOL-O_HN.indd 14
XSolar SOL-O S
242 × 53 × 91
max. 3.3 W
360°
max. 6 m
10 – 30 s automatically
3 %
max. 273 lm
83 lm / W
XSolar SOL-O S
Lithium iron phosphate (LiFePO 4)
2 × 2,000 mAH
20 days at 20 switching operations a night.
Cause
■ Battery capacity too low
■ Battery capacity too low
■ Detection zone not correctly adjusted
■ Continued movement within the detection
zone
■ Uncontrolled movement in the detection
zone: Wind is moving trees and bushes.
Cars in the street being detected.
Sudden temperature changes due to
weather (wind, rain, snow) or air expelled
from fans, open windows.
■ Light is swaying (moving) due to gusts
of wind or heavy rain
■ Solar panel dirty
■ Solar panel not installed in the best
place.
■ If the light is not used for a prolonged
period. The battery may be permanently
damaged from exhaustive discharge
(e.g. during storage)
- 14 -
XSolar SOL-O
242 × 38 × 91
max. 0.1 W
-
-
2 lux
-
-
max. 7.5 lm
75 lm / W
3,000 K
50,000 h
IP 44
III
-20 °C to +40 °C
XSolar SOL-O
2,000 mAH
5 V, max. 1 A
Remedy
■ Charge battery with micro USB
charging adapter
■ Charge battery with micro USB
charging adapter
■ Check detection zone
■ Check detection zone
■ Check detection zone
■ Mount light on a firm
surface
■ Clean solar panel with a soft cloth and
mild detergent
■ Check site of installation (as much
direct sunlight as possible)
■ Set programme selector switch to
P0 or OFF
■ The battery must be on full charge
before taking the light out of service.
■ Regularly charge the battery while the
light is not in use
XSolar SOL-O HN
242 × 183 × 91
max. 0.1 W
-
-
-
-
max. 7.5 lm
75 lm / W
XSolar SOL-O HN
2,000 mAH
06.11.23 16:40 06.11.23 16:40