Publicité
Les langues disponibles
Les langues disponibles
Mounting the stone cover:
1. Carefully place the first side stone on the dowels on the bottom plate
and place dowels in the two holes at the top of the side stone. Then fix
the stones by fixing the dowels to the body of the stove using the metal
brackets (see illustration).
2. Repeat step 1 with the middle and last stone.
3. Repeat step 1-2 on the opposite side.
4. Place the top stone on the dowels.
5. If the stove is mounted with the flue outlet at to the back of the stove,
then place the 3 adjustable "holders" between the inner stove and the
stone top in order to make sure that the small top plate can be placed
correctly and have the same height as the stone top plate.
2.6 Mounting of heat accumulating stones in Aduro 9.7
Aduro 9.7 comes with heat accumulating stones. Find instructions for mounting the stones at the back of this
user manual.
Important safety information:
•
The wood burning stove will become warm during use and therefore it should be treated with all
necessary caution.
•
Never keep easily combustible fluids such as petrol in the vicinity of the wood burning stove.
•
Never use easily combustible fluids to light the fire in the wood burning stove.
•
When lighting a fire and adding new wood logs, it is important to get the fire burning fast. If the fire
does not start quickly and wood only smoulders, it can cause strong smoke formation and in worst
case cause an explosive ignition of the flue gasses, which can damage the stove.
•
Never empty the ashpan when the wood burning stove is warm. Embers may still be found in the
ashpan for up to 24 hours after the fire has gone out. Please wait to empty the ashpan until you
are sure that there are no embers in the ash.
•
The door should be kept closed while the wood burning stove is in use. While lighting the fire, the
door can stand ajar for the first few minutes.
•
When putting logs in a hot stove, you must always open the primary air intake and make sure that
the wood ignites within 2-3 minutes. If the wood does not ignite, add some ignition products, and
ignite them manually. Please make sure that the flames are burning steadily for the first 10
minutes before you leave the stove.
•
In the event of a chimney fire: Close all the dampers on the wood burning stove and call the fire-
fighting service.
3.1 Air damper
The stove is equipped with air dampers for regulation of the primary and secondary air supply. The primary
air is used at the beginning to get the fire going, and the secondary air keeps the fire burning evenly. The
tertiary air ensures that flue gasses are burned and is not adjustable. You must always add secondary and
tertiary air, while firing the stove. The illustration below shows the stove with the air dampers indicated:
3. Lighting the stove
35
Publicité
