ADURO 1.1 Serie Mode D'emploi page 33

Aduro 1.1, 1.1SK, 1.4,
9, 9.1, 9.3, 9.4 & 9.5
Aduro 9.6
Aduro 9.7
2.3 Connection to a brick chimney
If the stove is being connected to a brick chimney you should use the rear outlet (this does not apply to
Aduro 9.6 & 9.7) or a curved flue pipe via the top outlet (or through the room above the combustion chamber
for Aduro 9.7). After measuring, a hole is made in the chimney in which the pipe sleeve is placed, and stove
mortar is used to seal it in place. The stove is placed in position and the flue pipe is put in place. A thin
gasket is placed between the flue pipe and the pipe sleeve to seal the joints The flue pipe should protrude
into the pipe sleeve but must not block the opening in the chimney (see the illustration below). You may
benefit from putting a slim gasket between the flue outlet on the stove and the flue pipe.
The stove can be connected to a chimney to which other heat sources are connected.
The stove leaves the factory with the flue outlet mounted on the top. If you
require the flue outlet on the back, "break" off the cover plate / plates
positioned at the top of the back of the stove. Exchange the exhaust connector
(from the top outlet) with the cover plate from the rear outlet. Mount the cover
plate from the rear outlet to the top outlet. The top outlet is finished with the
plate that lies in the ashpan. You may benefit from putting a slim gasket
between the flue on the stove and the flue pipe.
Specific for Aduro 1.1SK: If you choose to use the smoke outlet at the back of
the stove, it is important to mount the pipes before the stones are mounted.
Remember to place the cover plate correctly. See section 2.5.
The stove leaves the factory with the flue outlet mounted on the top.
The stove leaves the factory with the flue outlet mounted on the top. If you
require the flue outlet on the back, use a 90 flue pipe. Use a standard flue
pipe (see illustration below). The top outlet is finished with the plate that lies in
the ashpan. You may benefit from putting a slim gasket between the flue on
the stove and the flue pipe.
33