Publicité
Les langues disponibles
Les langues disponibles
NOTE: Leave nuts loose on this step, allowing the End Panels (1) to be adjusted later.
Step 2
Align an End Panel (1) with
the Aerator Tray (5).
- From beneath, run three 5/16" x 3/4"
Hex Head Screws (10) through the tray
and end panel.
- Add a 5/16" Flat Washer (14)
to each screw.
- Add three 5/16" Hex Nuts (12),
DO NOT TIGHTEN FULLY.
NOTE: These will be adjusted
and secured on Step 4-B.
Repeat on the other
end of the tray (5).
Step 3
Slide a Cotter Pin (19)
through the end of
the Tine Shaft (2). Using
pliers, bend the ends
over to secure the pin
in place.
English Manual
All manuals and user guides at all-guides.com
ASSEMBLY
1
14
+
12
10
Place a 5/8" Flat
Washer (15) on the
Tine Shaft (2) and push
the shaft through one
End Panel (1).
9
14
+
12
10
10
Add a Square Bearing (17) and a 5/8" Flat
Washer (15) on the Tine Shaft (2) as illustrated.
12
14
5
10
x6
1019098-B
Publicité
