Publicité
Les langues disponibles
Les langues disponibles
Step 4-B
Push the End Panels (1) toward the center until there is no free play along
the shaft. Tighten the six nuts (A) securing these panels fully.
A
Step 4-C
Add as many 5/8" Flat Washers (15) to the
opposite end of the shaft as necessary to eliminate
extra space. Fasten the remaining Cotter Pin (19)
on the end of the Tine Shaft (2).
Using pliers,
bend the Cotter
Pin (19) ends
over to secure
the pin in
place.
NOTE: Store extra flat washers (15) in a safe location. You may need them for maintenance.
English Manual
All manuals and user guides at all-guides.com
ASSEMBLY
NOTE: The Square Bearings must be
completely inserted into the end panels.
11
A
2
15
19
1019098-B
Publicité
