PANCONTROL PAN 185 Mode D'emploi page 42

All manuals and user guides at all-guides.com
1. Set the rotary switch to the position
2. Attach the pin-plug of the black test lead to the COM-jack and the
pin-plug of the red test lead to the V, Ω, Hz %-jack.
3. Connect the black test prod to the negative pole and the red test prod
to the positive pole of the circuit to be tested.
4. If the resistance is less than about 50 Ω, you hear an audible signal. If
the circuit is open, the display shows "OL".
Diode testing
1. Set the rotary switch to the position
2. Touch the diode to be tested with the probes. The forward voltage shows
400 to 700mV. The counter voltage shows „OL". Defective devices show a
value about 0 mV or „OL" in both polarities.
Frequency measurement and Duty cycle
1. Set the rotary switch to the position Hz %
2. Select with the FUNCTION button Hz or %
3. Attach the pin-plug of the black test lead to the COM-jack and the pin-plug
of the red test lead to the V, Ω, Hz %-jack.
4. Connect the black test prod to the negative pole and the red test prod to
the positive pole of the circuit to be tested.
5. Once the reading stabilizes, read the value. If the polarity is twisted a
"Minus sign" is displayed. Use the HOLD function if the reading is difficult
to read.
Capacity measurement
1. Set the rotary switch to the position
2. Attach the pin-plug of the black test lead to the COM-jack and the pin-plug
of the red test lead to the V, Ω, Hz %-jack.
3. For capacitors with known polarity connect the red test lead with the
anode and the black test lead with the cathode. Once the reading
stabilizes, read the value. Use the HOLD function if the reading is difficult
to read.
Relative mode (REL)
The relative measurement feature allows you to make measurements relative
to a stored reference value. A reference voltage (current, etc.) can be stored
EN 14