Features; Assembly - Ryobi CSB142LZ Manuel D'utilisation

PRODUCT SPECIFICATIONS
 Blade Diameter ................................................. 7-1/4 in.
 Blade Arbor ...........................................................5/8 in.
 Cutting Depth at 0° ........................................... 2-3/8 in.
 Cutting Depth at 45° ..................................... 1-13/16 in.
 Cutting Depth at 51.5° ...................................... 1-5/8 in.
KNOW YOUR CIRCULAR SAW
See Figure 1, page 17.
The safe use of this product requires an understanding of
the information on the product and in this operator's manual
as well as a knowledge of the project you are attempting.
Before use of this product, familiarize yourself with all
operating features and safety rules.
BLADE WRENCH STORAGE
Convenient wrench storage for quick blade changes.
DUST CHUTE
To direct saw dust and chips away from the operator, a dust
chute is located on the side of the upper blade guard.
DUST NOZZLE KIT
Installing the dust nozzle kit allows you to hook up your cir-
cular saw to a vacuum for convenient dust and chip removal.
EDGE GUIDE
The edge guide is used when making long or wide rip cuts
with the saw.
UNPACKING
This product requires assembly.
 Carefully remove the product and any accessories from
the box. Make sure that all items listed in the packing list
are included.
WARNING:
Do not use this product if any parts on the Packing List
are already assembled to your product when you unpack
it. Parts on this list are not assembled to the product by
the manufacturer and require customer installation. Use
of a product that may have been improperly assembled
could result in serious personal injury.

FEATURES

 Input ............................ 120 V, AC Only, 60 Hz, 14 Amps
 No Load Speed ...................................5,000/min. (RPM)
 Net Weight ........................................................... 11 lbs.
 Laser Guide ...................... Class II, <1mW max, 650nm
ERGONOMIC DESIGN
The design of your circular saw provides for maintaining
proper two hand control when cutting. It has been designed
to be comfortable and easy to grasp.
LASER GUIDE
When turned on, the laser guide will generate a red laser
beam on the work surface in front of the saw.
LED WORKLIGHT
The circular saw has a built-in LED worklight that illuminates
when the LED worklight button is depressed. This feature
is convenient when working in close or tight areas where
additional light is needed.
SPINDLE LOCK
The spindle lock allows you to secure the blade when turn-
ing the blade screw.
NOTE: Do not run circular saw with spindle lock engaged.
SWITCH
Your circular saw is equipped with a pre-travel safety switch
which reduces the possibility of accidental starting. When
you depress the switch, the saw will not start until you reach
the pre-travel position. You must depress the switch fully to
activate the saw.

ASSEMBLY

 Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the product.
 If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
PACKING LIST
Circular Saw
7-1/4 in. Blade
Blade Wrench
Edge Guide
Dust Nozzle Kit
Tool Bag
Operator's Manual
9 - English