Installing The Faceplate; Adjustments; Adjusting The Tool Rest - LEMAN TAB040 Manuel D'utilisation

Installing The Faceplate to the
Headstock
Thread the faceplate clockwise on to the
headstock spindle. Engage the spindle lock
and stop the spindle from turning. Tighten the
faceplate with the supplied wrench. (See Fig.07)
Warning: Disengage spindle lock before turning
the machine on.
Installing Tool Holder On the Lathe Bed
Located the tool holder from the carton, and
install it onto the lathe bed with
screws. (See Fig.08)
Secure Lathe to a Solid Work Surface
The lathe must be attached to a solid work
surface or stand. Four mounting holes are easily
accessible at the base of the lathe. (See Fig.09)

Adjusting the Tool Rest

The tool rest base can be easily moved along
the lathe bed. Loosen the locking lever counter
clockwise, slide the tool rest base to new position,
and tighten the locking lever clockwise.
To adjust the height of the tool rest, loosen the
locking arm, raise or lower the tool rest, then
tighten the locking arm. (See Fig.10)
Note: Position the tool rest as close to the work
piece as possible.
To adjust the clamping action of the tool rest
base, remove the base and adjust the nut
clockwise to tighten and counterclockwise to
loosen.(See Fig.11)
two pan head
Adjustments and Operations
5
EN
Spindle lock
Fig.07
Pan head screw
Fig.08
Mounting holes
Fig.09
Tool rest
Locking lever
Fig.10
Tool rest base
Locking arm
Fig.11
Faceplate
Tool holder
Tool rest base
Locking arm
Locking lever