Nokia N95 Guide D'utilisation page 150

Follow the instructions from your service provider.
Access point name
●
point name from your service provider.
User name — The user name may be needed to
●
make a data connection, and is usually provided
by the service provider.
Prompt password
●
password every time you log in to a server, or if
you do not want to save your password in the
device, select Yes.
Password — A password may be needed to
●
make a data connection and is usually provided
by the service provider.
Authentication
●
your password encrypted or
your password encrypted when possible.
Homepage — Depending on the access point
●
you are setting up, enter the web address or the
address of the multimedia messaging centre.
Select Options
>
the following settings:
Network type
●
type to transfer data to and from your device. The
other settings depend on the selected network
type.
Phone IP address
●
address of your device.
DNS address
●
150
primary and secondary DNS servers, if required
All manuals and user guides at all-guides.com
— You obtain the access
— If you must enter the
— Select Secure to always send
Normal to send
Advanced settings to change
— Select the internet protocol
(for IPV4 only) — Enter the IP
— Enter the IP addresses of the
by your service provider. Contact your internet
service provider to obtain these addresses.
Proxy server address
●
the proxy server.
Proxy port number
●
of the proxy server.
WLAN internet access points
Press , and select Tools
Connection Access points
>
or New access point.
Follow the instructions from the WLAN service
provider.
WLAN network name
●
manually or Search for
an existing network,
WLAN security mode
settings of its access point device.
Network status — Define whether the network
●
name is displayed.
WLAN network mode
●
create an ad hoc network and to allow devices to
send and receive data directly; a WLAN access
point device is not needed. In an ad hoc network,
all devices must use the same
name.
WLAN security mode
●
used: WEP, 802.1x (not for ad hoc networks), or
WPA/WPA2. If you select
— Enter the address of
— Enter the port number
Settings
> >
Options Edit
> >
— Select Enter
networks. If you select
WLAN network mode and
are determined by the
— Select Ad-hoc to
WLAN network
— Select the encryption
Open network, no