Publicité
PLACING THE LAMP.
User's precautions:
- Use only Philips MSR 1800DE lamp.
- Disconnect from the mains.
- Lamp is cold.
- Avoid touching the bulb of the lamp.
- Open the side trapdoors of the lamp house.
- Use only when lamp is in place.
Preparing the lamp:
- Unscrew the nuts 1 without completely taking them off.
Installing the lamp :
- Place the lamp into the contacts 2 and
the tip-off in the upper position D .
- Tighten the nuts 1 firmly, by hand.
Warning : A bad lamp tightening can cause
a bad contact and a defective
ignition. Check regularly that the
nuts 1 are well tightened.
Lamp :
Warning - Do not use a lamp, if the diameter
of the bulb is greater than Ø28,5mm.
SWITCHING ON /OFF
Warning : • Carry out the connections before
connecting to the mains (refer to section A - 5 or 7).
• Let the lamp house fan run for 10 min before switching
the circuit breaker off.
- No matter in what the position of the circuit breaker 3 ,
make sure that the mains checklight 4 is ON.
- Engage the circuit breaker 3 .
- Press the switch 5 to "ON" .
- To switch the lamp off, press the switch to the "OFF" position.
robert juliat
Route de Beaumont F 60530 Fresnoy-en-Thelle - phone: +33 (0)3.44.26.51.89 - fax: +33 (0)3.44.26.90.79 - www.robertjuliat.fr
All manuals and user guides at all-guides.com
TECHNICAL FILE
1800W MSR FOLLOWSPOTS
Disconnect from the mains before any servicing.
Service only by qualified technician.
1
FLO / VICTOR
A
B
2
B
C
D
1
A
180
4
5
3
Section A - 9
C
D
E
2
E
Ø28,5mm Maxi
Publicité
