JVC EXAD KD-AVX11 Manuel D'instructions page 45

Equalizer
Menu items
Flat/Hard Rock/R&B/Pop/Jazz/
Dance/Country/Reggae/Classic/
User1/User2/User3
Sound
Menu items
Fader/Balance
Adjusts fader
Adjust balance
Volume Adjust
Subwoofer
High Pass Filter
Crossover
Amplifier Gain
Selectable settings, [reference page]
☞ [37]
Selectable settings, [reference page]
Adjust fader—speaker output balance between the front and rear
speakers.
• Upmost—front only
• Downmost—rear only
When using a two-speaker system, set the fader to the center (00).
Adjust balance—speaker output balance between the left and right
speakers.
• Leftmost—left only
• Rightmost—right only
Adjust and store auto-adjustment volume level for each source,
comparing to the FM volume level. The volume level will automatically
increase or decrease when you change the source.
–12 to +12; Initial 00
Adjust the settings below in the submenu:
Phase : Subwoofer phase. Select either <Normal> or <Reverse>,
which reproduces a better sound.
Level: Subwoofer output level. Level: –06 to +08; Initial 00
Through : Select when the subwoofer is not connected.
On : Select when the subwoofer is connected.
Adjust the crossover frequency between the front/rear speakers and the
subwoofer.
80Hz, 120Hz, 150Hz
You can change the maximum volume level of this unit.
Off : Deactivates the built-in amplifier.
Low Power : VOL 00 to 30 (Select this if the maximum power of the
speakers is less than 50 W)
High Power : VOL 00 to 50
45
SETTINGS