Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
Before first use
For a freestanding appliance; 'this refrigerating
•
appliance is not intended to be used as a built-in
appliance.
Your refrigerator should be installed at least 30
•
cm away from heat sources such as hobs, ovens,
central heater and stoves and at least 5 cm away
from electrical ovens and should not be located
under direct sunlight.
The ambient temperature of the room where
•
you install your refrigerator should at least be
+10°C. Operating your refrigerator under cooler
conditions is not recommended with regard to its
efficiency.
Please make sure that the interior of your
•
refrigerator is cleaned thoroughly.
When you operate your refrigerator for the first
•
time, please observe the following instructions
during the initial six hours.
The door should not be opened frequently.
•
It must be operated empty without any food in it.
•
Do not unplug your refrigerator. If a power
•
failure occurs out of your control, please see the
warnings in the "What to do if" section.
Original packaging and foam materials should be
•
kept for future transportations or moving.
The baskets/drawers that are provided with the
•
chill compartment must always be in use for
low energy consumption and for better storage
conditions.
Food contact with the temperature sensor in
•
the freezer compartment may increase energy
consumption of the appliance. Thus any contact
with the sensor(s) must be avoided.
In some models, the instrument panel on display
•
automatically turns off 1 minutes after the door
has closed. It will be reactivated when the door
has opened or pressed on any key.
When temperature change caused by door
•
opening/closing frequently, condensation on
door/body shelves and the glass containers may
be seen.
Since hot and humid air will not directly penetrate
•
into your product when the doors are not opened,
your product will optimize itself in conditions
sufficient to protect your food. Functions and
components such as compressor, fan, heater,
defrost, lighting, display and so on will operate
according to the needs to consume minimum
energy under these circumstances.
In case of multiple options are present glass
•
shelves must be placed so that the air outlets
at the backwall are not blocked, prefably air
outlets are remaining below the glass shelf. This
combination may help impoving air distribution
and energy efficiency.
Installation of the Cooler and Freezer Products
Side-by-side
When the freezer and cooler products are installed
side by side, the installation should be performed so
that the freezer product will be on the left and the
cooler product will be on the right. To prevent sweating
problems that might occur between products, anti-
condensation elements are located on the left side of
the cooler product.
Freezer
Cooler
9
Publicité
