Continuous Operation; Maintenance And Service; Maintenance And Cleaning - stayer DM1450 Instructions D'emploi

Operation and use
Improper use can cause damage to the tool. Please ob-
serve the following instructions:
- only use tools up to the prescribed diameter.
- only use the tool at loads which do not reduce the
speed severely or bring the tool to a standstill.
- Check whether the data on the type plate comply with
the actual voltage of mains supply. Tools intented for
230 V. may also be connect to 220 V. / 240 V.
Fitting the mixing tool
Screw the tools with the end piece M14 x 2 as far as pos-
sible into the tool holding fixture and tighten with the span-
ner (22 mm.) included in the accessories.
Switching on and off
To switch the tool on, press the switch 5 and hold it down.
To switch the tool off, release the switch 5.
Model DM L20: To start push trigger 8 forward and press
switch 5. To switch off, release switch 5.

Continuous operation

To switch on continuous operation: press the switch
5 up to the stop and at the same time press the locking
button 6. The switch 5 locks, and continuous operation is
activated.
To switch off continuous operation: press the switch 5
again and then let go. The lock on the switch 6 is released,
and continuous operation is deactivated.
Removing tools (mixer)
Fit the flat spanner (22 mm) onto the hexagon of the tool
end piece (mixer) and turn to the left to unscrew the tool
from the spindle.
Motor electronics / Operating
motor electronics
ENGLISH
11
Starting current limiting
The electronically controlled soft start ensures that the
machine starts smoothly. This also prevents spray from
thin liquids when the tool is switched on.
The lower starting current means thar a 16 A fuse is large
enough for the machine.
Preselection of rotation
With the rotational adjustments can be preselected power
progressively rotation. The rotation required depends on
the material to be it is advisable to pre- mix and make
acheck through a practical control.
Gear selector
In models with two mechanical speed 1 speed , high tor-
que for thick mixtures and speed 2 , medium pair , for
lighter blends that enable faster work is used. With the
machine off using the selector 1 to change the fly.
It is possible to change fear when the machine is running.
However , this should not be done wen the machine is at
full load.
Operating Instructions
The choice of stirrer paddle depends on the material to
be stirred. For materials with low viscosity, e. g., disper-
sion paint, varnish, adhesions, casting compound, cement
grout, etc., use a stirrer paddle with left-hand spiral.
For materials with high viscosity, e. g., ready-mixed plas-
ter, concrete, cement, screed, filler, epoxy resin, etc., use
a stirrer paddle with right-hand spiral. While mixing, move
the power tool in an up and down motion. Clean the stirror
paddle after use.

Maintenance and Service

Maintenance and Cleaning

- Before any work on the machine itself, pull the
mains plug.
- For safe and proper working, always keep the ma-
chine and ventilation slots clean.
If the machine should fail despite the care taken in m
nufacturing and testing procedures, repair should be
carried out by an after-sales service centre for Stayer
power tools.
11