Brüel & Kjaer Vibro AC-4705 Instructions D'emploi page 8

EN
User Qualification
Settings can be effected on systems which if incorrect can cause serious damage to machines and/or
persons.
Ensure that all work in conjunction with our systems is performed by skilled, expert and authorized
workers. Among these works are:
Installation and Commissioning
Installation and commissioning primarily concern work on electrical equipment. These works may be
performed exclusively by electricians or workers instructed and supervised by an electrician in
accordance with electrotechnical regulations/directives.
Change of System Specification
Any change of system specification has its effects on monitoring process with stationary systems and
on the measuring sequence with portable measuring systems.
Maintenance and Repair
There is no maintenance or repair. In the case of a defect, the device hast to be replaced.
Intended Use
Use system exclusively as originally intended. Any use other than originally intended is prohibited.
Brüel & Kjær Vibro does not assume any liability for damages resulting from inappropriate use.
The user is solely responsible.
Ensure that system is exposed only to admissible environmental influences.
Product Description
3
2
1
Figure 1) connection description AC-4705
█
Page 8 of 18
5
4
7
8
1) U : 24 VDC Power-Connection;
IN
(Direct connection) PWR1
2) U : 24 VDC Power-Connection; PWR2
IN
(Connection to an additional AC-4705)
3) Interface RJ45 to VI-6080 (OUTPUT)
6
4) Jumper with 3 wire connection
GND = COM; J1 to J4
5) Sensor connector panel: Ch1 to Ch4
6) Strain relief / shield support
7) LED - Power on
8) Jumper: Shield - Top hat rail; -J5
© Brüel & Kjaer Vibro ● C106330.001 / V02 ●
Technical alterations reserved!