Publicité
Les langues disponibles
Les langues disponibles
If needed, fit the RSE card
table
(*) and set up a peripheral number for each control
board (see function [peripheral number] in the operator's
or the control panel's manual.
For stretches exceeding 100 m, use ⓓ
resistors between terminals (A-B) on either end of the
RS-485 cable.
All of the operators connected to the module must
be configured on the control panel, in CRP mode (see the
"managing serial connections" function) with the Baud
rate set at 38400 (see the "change COM speed" function
in the operator's manual or on the control panel).
(*) The module compatibility table is available at the
following address:
http://www.cameconnect.net/came/docs/cameconnect_
compliant_devices.html
Configuring the module
The programming software is WINDOWS VISTA OS or
a more recent version-compatible
To configure the module, proceed as
- download the latest Connect GW Configurator
software version from the Download area at
ⓔ
All manuals and user guides at all-guides.com
see the module compatibility
150 ohm
follows:
http://www.cameconnect.net
- select the connection type (GSM, Wi-Fi or Ethernet)
and fill in all the required fields; then press[save*
to create the [T060xx_config.ini] configuration file;
[T060xx_config.ini];
- save the configuration file to a USB drive, fit the USB
drive into the module's USB port (Attention! The module
must be powered up=;
- power up the module to copy the configuration file;
LED 3 will flash quickly for two seconds during the
configuration phase;
- remove the USB drive (if the module is configured
for Wi-Fi or Ethernet mode, fit the Wi-Fi drive or the
Ethernet drive).
The device restarts alone once configuration is complete.
⚠
Check that the configured services are working
properly by observing the LED signals; see Legend.
Configuration CAME CONNECT
To configure the module on Came Connect, see the
ConnectGW software configuration manual
the Documents at
http://www.cameconnect.net
available in
Publicité
