7
1
VE1120
J4
J3
CP
VE1120
2
J4
J3
CP
Ω
Normal
4.7 k
A
larm
9.4
kΩ
Tamper
Ω
Short
0
EN: Installation Sheet
Introduction
The VE1100 series includes the VE1100 PIR and VE1100AM
PIR-AM motion sensors. They have a patented mirror, pyro,
and signal processing technology.
Installation guidelines
The technology used in these detectors resists false alarm
hazards. However, avoid potential causes of instability (see
Figure 1) such as:
•
Direct sunlight on the detector
•
Strong draughts onto the detector
•
Heat sources within the detector field of view
•
Animals within the detector field of view
•
Obscuring the detector field of view with large objects,
such as furniture
•
Objects within 50 cm (20 in.) of the anti-masking (AM)
detector
•
Installing two detectors facing each other and less than
50 cm (20 in.) apart (only AM detectors)
P/N 146279999-2 • REV 3.0 • ISS 20JUL10
J4
J3
J4
J3
J4
J3
Ω
Normal
4.7 k
A
larm
9.4
kΩ
Tamper
Ω
Short
0
VE1120AM
J4
J3
CP
VE1120AM
J4
J3
CP
Ω
Normal
4.7 k
A
larm
9.4
kΩ
Tamper
Ω
Short
0
AM/TF
Installing the detector
Figure 7 legend
Item
Description
1.
Standard connection (factory default)
2.
Dual loop connection
CP
Control panel
WT
Walk test
AM
Antimasking
D/N
Day/night
Rtest
Remote test
To install the detector:
1.
Lift off the custom insert and remove the screw
(see Figure 2, step 1).
2.
Using a screwdriver, carefully prise open the detector (see
Figure 2, steps 2 and 3).
3.
Fix the base to the wall between 1.8 and 3.0 m (5.9 and
9.8 ft.) from the floor. For flat mounting use a minimum of
two screws (DIN 7998) in positions A. For corner-mounting
J4
J3
J4
J3
J4
J3
CP
Ω
Normal
4.7 k
A
larm
9.4
kΩ
Tamper
Ω
Short
0
AM/TF
3 / 20