Publicité
Les langues disponibles
Les langues disponibles
Cleaning the exterior
Turn off the water faucets after finishing the day's washing.
This will shut off the water supply to your Washer and prevent
the unlikely possibility of damage from escaping water. Leave
the door open to allow the inside of your Washer to dry out.
Use a soft cloth to wipe up all detergent, bleach or other spills as
they occur.
Clean the following as recommended:
Control Panel – Clean with a soft, damp cloth. Do not use
abrasive powders or cleaning pads. Do not spray cleaners
directly on the panel.
Cabinet – Clean with soap and water.
Cleaning the interior
Clean the interior of your Washer periodically to remove any dirt,
soil, odor, mold, mildew, or bacterial residue that may remain in
your Washer as a result of washing clothes.
Failure to follow these instructions may result in unpleasant
conditions, including odors and/or permanent stains on your
Washer or laundry.
Hard water deposits may be removed, if needed. Use a cleaner
labeled "Washer safe".
Cleaning the dispensers
The automatic dispenser may need to be cleaned periodically
due to laundry additive buildup.
1 . Pull out the detergent liquid from detergent compartment.
2 . Remove the siphon cap from the fabric softener and bleach
compartments.
Siphon cap
3 . Wash all of the parts under running water.
4 . Clean the dispenser recess with a soft brush.
5 . Reinsert the siphon cap and push it firmly into place.
6 . Push the dispenser back into place.
7 . Run a Rinse+Spin cycle without any load in your washer.
Kenmore_Grace_User_03289C_EN_160425(add 699).indd 29
All manuals and user guides at all-guides.com
Cleaning the debris filter
We recommend cleaning the debris filter when water does not
drain well.
1 . Gently press the top area of the filter cover to open.
2 . Unscrew the drain cap by turning it counterclockwise.
3 . Hold the cap on the end of the drain tube and slowly pull it
out about 6inches (15cm) and drain off all the water.
4 . Remove the debris filter cap.
5 . Wash any dirt or other material from the debris filter. Make
sure the drain pump propeller behind the debris filter is not
blocked.
6 . Replace the debris filter cap.
7 . Replace the filter cover.
8 . Close up the opening of drain tube with cap.
9 . Don't insert the drain tube in the hole.
Step 1
Step 2
29
2016/5/26 10:09:39
Publicité
