Publicité
Les langues disponibles
Les langues disponibles
Secure the Drain Hose
1 . Drape the power cord over the washer top.
2 . Move the washer to its final location.
3 . Place the drain hose in the laundry tub or standpipe as
shown. See illustrations A and B.
A
B
4 . If the washer faucets and the drain standpipe are recessed,
put the hooked end of the drain hose in the standpipe as
shown. See illustration C.
NOTES:
■ Do not force excess drain hose back into the rear of the
washer.
■ To avoid siphoning, do not seal the drain hose into the
standpipe.
Level the washer
Level your washer by turning the leveling legs in or out as
necessary by hand or the wrench. When your washer is level,
tighten the nuts using the wrench or (-) driver.
NOTES
■ Your Washer must be leveled on all four sides. A carpenter's
level should be used on all four corners of your Washer. It's
a good idea after the first dozen washes to recheck your
washer's levelness.
■ To avoid damage to the legs, do not move the Washer unless
the Lockingnuts are fastened to the bottom of the Washer.
Kenmore_Grace_User_03289C_EN_160425(add 699).indd 13
All manuals and user guides at all-guides.com
C
13
2016/5/26 10:09:31
Publicité
