Publicité
Les langues disponibles
Les langues disponibles
Important note to installer
Please read the following instructions carefully before installing
your Washer.
These instructions should be retained for future reference.
We recommend you hire a professional for installation of this
washer.
Installation flow chart
Selecting a
Removing the shipping
location
bolts (*Drum only)
Adjusting the
levelling feet
Please
check again
before steps.
Does
your washer have
excess vibration
Yes
or noise?
Calibration mode
Before using Calibration mode, be sure to take out all items from
the drum.
Your Kenmore Elite washer automatically detects the weight of
the laundry.
For more accurate weight detection, please run Calibration
Mode after the installation.
Calibration mode is performed by following the steps below.
1 . Turn on the washer.
2 . Press the Temp. button and Delay End button simultaneously
at least 3 seconds.
3 . Remove any contents in the tub and close the door.
4 . Press the Start/Pause button to run Calibration Mode.
5 . The drum rotates clockwise and counterclockwise
approximately for approximately 3 minutes.
6 . When Calibration Mode is finished, the "0" appears on the
display and the washing machine turns off automatically. The
washing machine is now ready for use.
14
Kenmore_Grace_User_03289C_EN_160425(add 699).indd 14
All manuals and user guides at all-guides.com
Connecting the water and
the drain
Powering your
washing machine
[Running a test cycle]
Run a test cycle (Rinse+Spin)
with small amount of laundry
(about 4~5 Towels)
Running a Calibration
Finish the
mode (Refer to the
installation
following description)
No
Complete Installation
1 . Check the electrical requirements. Be sure that you have the
correct electrical supply and the recommended grounding
method. See "Electrical Requirements."
2 . Check that all parts are now installed. If there is an extra part,
go back through the steps to see which step was skipped.
3 . Check that you have all of your tools.
4 . Dispose of or recycle all packaging materials.
5 . Check that the water faucets are on.
6 . Check for leaks around faucets and inlet hoses.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet .
Do not remove ground prong .
Do not use an adapter .
Do not use an extension cord .
Failure to follow these instructions can result in death,
fire, or electrical shock .
7 . Plug into a grounded 3 prong outlet.
8 . Read "Washer Use."
9 . To test and to clean your washer, using only "HE" High
Efficiency detergent, measure ½ the amount of detergent
recommended by the manufacture for a medium size load.
Pour the detergent into the detergent dispenser. Select
NORMAL/CASUAL, and then select START. Allow the washer
to complete one whole cycle.
Use only HE High Efficiency detergent.
NOTES
■ Test run
Make sure that you install your washing machine correctly
by running the Rinse+Spin cycle after the installation is
complete.
2016/5/26 10:09:32
Publicité
