Publicité
Les langues disponibles
Les langues disponibles
EN
Remote Control Instructions
Remote lever
Power switch
Display
1. Power on button "
": Please keep long pressing of this button
for 2s to enter power-on state after loading into the battery in
remote control. Short press this button to check the Bluetooth
connection status. When "P0" is displayed, the Bluetooth is not
connected. "P1" means Bluetooth is connected. Keep pressing this
button for 2s to enter into shut-down state.
28
Power light
Mode switch
2. Turn on network distribution mode: When the remote control is
turned on, keep long pressing this power switch and mode switch
button until "P0--" pops out to indicate that it is in the distribution
network. At this time, keep long pressing the Quickstart button "5"
and "8" of treadmill at the same time. And then let go when the
treadmill system sends two "BEEP" sounds. When "P1" is displayed,
it is matched successfully.
3. Mode switch button "
": Click this button to see the current
exercise time, click again to display the distance, calories, heart rate
and that cycle repeats.
4. Remote lever: When the treadmill is in standby mode, keep
pressing the "remote lever" upward for 3s to start the treadmill.
When the treadmill is running, press the "remote lever" upward to
increase the speed by 0.1mph, and keep pressing the "remote lever"
upward to increase the speed until it reaches the maximum speed.
Press the "remote lever" downwards to reduce the speed by
0.1mph, and keep pressing the "remote lever" downwards to reduce
the speed of the treadmill until it reaches 1.0mph; and if you
continue to press the "remote lever" downwards for 3s, the treadmill
will stop running. The volume decreases when the "remote lever"
turns to the left and increases when the "remote lever" turns to the
right.
5. Bluetooth connection: Short press the power on button and
display "P0" to indicate Bluetooth disconnected. And "P1" to indicate
Bluetooth connected. When the Bluetooth of remote control is
disconnected for 5 minutes, the remote control will shut down
automatically.
6. Heart rate detection: When in power-on state, please long press
on the front sensor of the remote control, after about 30 seconds,
the remote control will display real-time heart rate.
EN
29
Publicité
