Publicité
Les langues disponibles
Les langues disponibles
EN
3. Adjust tightness of running belt. All treadmills shall be
adjusted for tightness before delivery and after installation.
However, the running belt may be loosened after a period of
use. For example, the treadmill had stopping and slipping
problems during exercise. When this phenomenon occurs,
adjust the running belt adjustment bolts in a clockwise
direction with a half circle as the unit, left and right
synchronously. If the running belt is too loose, the running
belt and the roller will make your feet slip, but too tight is
not good, and it is easy to increase the load of the motor and
damage the motor, running belt and roller.
4.Running belt deviation adjustment
All treadmills need to be adjusted the running belt before delivery
and after installation. But the running belt may be deviated after a
period of use which may be caused by the following reasons.
① The main body is not placed smoothly.
② The feet of users are not in the center of the running belt.
③ The feet of users are uneven force.
The deviation caused by man can be returned to normal after
a few minutes of no-load rotation. For deviation of
non-recover automatically, it should be adjusted with 6mm
wrench at a half circle as the unit.
Please adjust left bolt with
clockwise or right bolt with
counterclockwise if running
belt is left deviation.
26
Please adjust right bolt with
clockwise or left bolt with
counterclockwise if running
belt is right deviation.
Tips: It is mainly maintained by the user according to the manual.
Running belt deviation will seriously damage the running belt. The
mistake must be found in time and corrected.
5. Adjustment of the motor belt (as shown below)
All treadmills have been adjusted for the motor belt before and
after installation, but there may be slack and slipping after a
period of use, which is mainly adjusted by the user.
Adjustment steps:
① Adjust the parallelism of the motor with a wrench. Turn the
motor balance adjustment bolt half a turn counterclockwise.
② Turn the belt tightening bolts clockwise half a turn.
NOTE: Clean the belt and pulley groove regularly.
Belt tension bolt
Motor
Motor belt
Front roller
EN
Motor balance
adjustment bolt
27
Publicité
