Publicité
Les langues disponibles
Les langues disponibles
EN
10. Common failures and processing method
please contact our after-sales service if you have any other questions
Problems
Possible causes
Not connected
Power is not turned on
Treadmill
Safety lock drop
doesn't work
Circuit signal system
break
The fuse blown out
The running
Insufficient lubrication
belt doesn't
run smoothly
Running belt is too tight
Running belt is too loose
Running belt
slipped
Motor belt is too loose
Error code:
The following table is abnormal with the control
E01
communication
E05
Under control over current protection
Safety lock falls off
E07
Abnormal communication between the table
E11
above and the table below
24
Maintenance Methods
Put plug to into the socket
Put the power switch in
position "ON"
Put the safety lock in
correct position
Check the controller input
terminal and signal circuit
Replace fuse
Add silicone oil lubricant
Adjust running belt tightness
Adjust running belt tightness
Adjust motor belt tightness
11. Product maintenance
1. Lubrication
After the running belt has been used for a period of time, it must
be lubricated with a specially configured methyl-silicone oil.
Advice:
★
1 hour or less per week
★
Less than 3 hours per week
3-6 hours per week
★
Do not lubricate too much. It is not the more lubricants the better.
Remember: Proper lubrication is an important factor in improving
the life of the treadmill.
2. As for the way to check whether you need to add lubricant
again. Just grab the running belt and touch the middle of the
running belt back with your hands as much as possible. You
don't need to add lubricant if you have silicone on your hand
(a little moist). You have to add lubricant if the pad is dry
and there is no silicone on your hand.
★ The step of lubricating on the running board (as shown in the
picture);
★ Stop the running belt and fold the machine;
★ Lift up the running belt on the bottom, extend the oil into the
middle of the running belt as much as possible, spray
methyl-silicone oil on the inner side of the running belt, and coat
both sides of the running belt with methyl-silicone oil;
★ You can make use of the treadmill
speed of 0.6mph to evenly lubricate and
step on the running belt from left to
right. After a few minutes, the methyl
silicone oil can be completely absorbed
by the running belt.
lubricate once every 6 months
lubricate once every 3 months
lubricate once every 2 months
EN
25
Publicité
