Publicité
Les langues disponibles
Les langues disponibles
3. Fishwire fasteners – Use the provided fishwire to install the spacer and carriage bolt into the frame, start by inserting the coiled end through the attachment hole
(furthest from the access hole first) then out through the access hole, attach the spacer and carriage bolt to the fishwire, then pull the bolt up to the attachment hole.
Leave the fishwire attached. See figure 2 for example. Repeat for other side.
4. Install hitch – Raise the hitch into position, feed ends of pullwires through holes in hitch and pull the 7/16" fasteners through the attachment holes in the hitch,
remove pullwire, apply blue thread locker, and loosely install conical washers and supplied 7/16" nuts, both sides.
©2023 Horizon Global Americas Inc. - Printed in Mexico
FRAME
ACCESS HOLE
KINK BOLT LEADER
TO KEEP BLOCK
INDEPENDENT OF BOLT
EXAMPLE OF FISHWIRE PROCEDURE
Sheet 5 of 18
76638NP
DESIRED BOLT
ATTACHEMENT HOLE
Figure 2
4-05-23
Rev. A
Publicité
