Electrolux EMT25203C Notice D'utilisation page 17

• The cabinet can not have a back wall
in the place where the microwave is
located.
• Put the microwave far away from
steam, hot air and water splashes.
• If the microwave is to close to the TV
and radio it may cause interference in
the received signal.
• If you transport the microwave in cold
weather, do not activate it
immediately after the installation. Let
is stand in the room temperature and
absorb the heat.
12.2 Electrical installation
WARNING!
Only a qualified person must
do the electrical installation.
The manufacturer is not
responsible if you do not
follow the safety precautions
from the chapter "Safety
Information".
This microwave is supplied with a main
cable and main plug.
The cable has an earth wire with an
earthing plug. The plug must be plugged
into an outlet that is properly installed
and earthed. In the event of an electrical
short circuit, earthing reduces the risk of
electric shock.
12.3 Installing the microwave
1. Check if the dimensions of the
furniture meet the installation
distances.
C
D
A
B
Installation distances
Dimension
A
B
C
D
2. Put the template on the bottom of
cabinet and check if it fits. If yes,
mark the spots for screws. Remove
the template and fix the bracket with
the screws (A) in the marked spot.
A
=
3. Install the microwave. If you fixed the
bracket, make sure it locks the back
of the appliance.
4. Open the door and fix the microwave
to the cabinet with a screw (B).
ENGLISH 17
mm
380 + 3
560 + 8
500
45
=