Craftsman 919.725502 Mode D'emploi page 18

SERVICE AND ADJUSTMENTS
Unit cycles
automatically
when power is on. When doing
Maintenance, you may be exposed
to voltage sources, compressed air
or moving parts. Personal injuries
can occur. Before performing any
Maintenance or repair, unplug the
compressor and bleed off all air
pressure.
ALL MAINTENANCE AND REPAIR
OPERATIONS NOT LISTED MUST
BE PERFORMED BY TRAINED
SERVICE TECHNICIAN.
To Replace or Clean Check
Valve
1. Release all air pressure from air
tank. See "To Drain Tank" in the
Maintenance section.
2. Unplug unit.
3. Using a phillips screwdriver
remove the air filter cover.
4. Remove the rear shrouds using
T-20 torx wrench.
5. Using an adjustable wrench
loosen outlet tube nut at air tank.
Carefully move outlet tube away
from check valve.
6. Using an adjustable wrench
loosen pressure relief tube nut at
air tank. Carefully move pressure
relief tube away from check
valve.
A14123
All manuals and user guides at all-guides.com
7.
8.
9.
10. Apply sealant to the check valve
11. Replace the pressure release
12. Replace the outlet tube and
13. Replace the shroud and air filter.
14. Perform the Break-in Procedure.
18- ENG
Outlet Tube
Pressure
Relief
Tube
Nut
Unscrew the check valve (turn
counterclockwise) using a 7/8"
open end wrench. Note the
orientation for reassembly.
Using a screwdriver, carefully
push the valve disc up and
down. NOTE: The valve disc
should move freely up and down
on a spring which holds the valve
disc in the closed position, if
not the check valve needs to be
cleaned or replaced.
Screwdriver
In open
position
nothing is
visible.
In closed position
disc is visible.
Clean or replace the check
valve. A solvent, such as paint or
varnish remover can be used to
clean the check valve.
threads. Reinstall the check valve
(turn clockwise).
tube. Tighten nut.
tighten nut.
See "Break-in Procedure" in the
Operation section.
Nut
Check
Valve