Milwaukee PD2-20 Instructions D'utilisation page 5

Three jaw chuck
(according to
standard
equipment)
Changing the
three jaw chuck
Inserting tools
Setting the
depth gauge
ENGLISH
All manuals and user guides at all-guides.com
Due to the high power potential of the
percussion drill the chuck might get stuck
at very high load and can not be opened
by hand.
In this case, please steady the chuck head
with a fork wrench and loosen the front
sleeve of the chuck with aid of a footprint
anti–clockwise (see illustration). The use
of a footprint will not cause any damage to
the chuck.
Always disconnect the plug from the socket before carrying out any work on the
machine.
1.
Open the chuck and loosen the locking
screw with aid of a screwdriver by turning
it clockwise.
2.
Hold the drive shank with the open-jaw
spanner.
3.
Insert the drill chuck key in the drill chuck
and loosen the drill chuck to the left by
tapping it lightly with a rubber hammer.
4.
Mount the chuck in reverse order.
The chuck can be used for drill bits or
screwdriver bits. For this purpose, open
the chuck, insert the selected bit and
secure by tightening the chuck with the
chuck key.
To remove tools insert chuck key into one
of the three holes at the chuck mouth and
turn anti- clockwise.
For drilling the required depth, insert the
depth gauge into the provided boring in the
handel and fasten it at the required drilling
depth.
4
1
PD2-20, PD2E 20 R